Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A generating station is to give a power output of 200 M.w. the superheat outlet pressure of the boiler is to be 170 bar and the temperatre 600°c after expansion through the first-stage turbine to a pressure of 40 bar. 151% of the steam is extracted for feed heating. The remainder is reheated at 600°C and is then expanded through the second turbine stage to a condenser pressure of 0.035 bar. For preliminary calculations it is assumed that the actual cycle will have an efficiency ratio of 70% and that the generator mechanical and electrical efficiency is 95%. Calculate the maximum continuous rating of the boiler in kilograms per hour.
A satellite changes its orbit inclined 66 degrees at 260.0 km altitude to a polar orbit at the same altitude. What Delta V was required?
in a paint plant semiautomatic mixers are normally used. it takes 8 minutes for an operator to load a mixer with the
Compare the moment capacity of the beam in part a with that shown in the figure part b which has two 4 in. ×12 in. joists (nominal dimensions) attached to a 1/4 in. × 11.0 in. steel plate
Making reasonable assumptions, evaluate if this is a reasonable claim or a gross exaggeration.
CeO2 is an important energy material for application in fuel cells. What kind of bonding do you expect between Ce and O in this material? Why? Which broad class of material would this oxide belong to? The ionic radius of Ce4+ and O2- are 0.102 and 0...
Determine the thickness of the 1.09m inside diameter pilot sphere (assume 4130 steel with ultimate tensile strength of 1,234MPa and a 200% factor of safety). The depth at which the sphere will fall is 10,908 meters.
An elevator is hung by a steel rope. The rope has a cross-sectional area of 250mm2 and a modulus of elasticity of 70 GPa. the upward acceleration when the elevator starts is 4 m/s2. the rope is 100m long and the elevator weigh 1000 kg. determine the ..
a gas turbine for an automobile is designed with a regenerator. air enters the compressor of this engine at 100 kpa and
A piston cylinder holds air at 80 degree F and 15 psi. During an adiabatic process the pressure increased to 165 psi and the entropy generated is 0.15 Btu/lb-degree R. Determine the isentropic efficiency for this
a police car is traveling at a velocity of 15.0 ms due north when a car zooms by at a constant velocity of 37.0 ms due
a turbine is designed to extract energy from a water source flowing through a 10 cm diameter pipe at a pressure of 800
the compressor and turbine of a simple gas turbine engine each have isentropic efficiencies of 95. the compressor
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd