A symmetric compound channel in over bank flow has a main

Assignment Help Civil Engineering
Reference no: EM13384379

A symmetric compound channel in over bank flow has a main channel with a bottom width of 30 m, side slopes of 1:1, and a flow depth of 3m. The floodplains on either side of the main channel are both 300m wide and flowing at a depth of 0.5m. The mean velocity in the main channel is 1.5 m/s, while the floodplain flow has a mean velocity of 0.3m/s. assuming that the velocity variation within the main channel and the floodplain subsections is much smaller than the change in mean velocities between subsections, find the value of the kinetic energy correction coefficient

Reference no: EM13384379

Questions Cloud

Determine thenbspmagnitudes of the additional loads that : a concrete foundation mat in the shape of a regular hexagon ofnbspside 12 ft supports four column loads as shown.
If the three gases are mixed in a rigid container at 500 k : consider the following reaction where kp 2.01 at 500 kpcl3g cl2g pcl5gif the three gases are mixed in a rigid
When carbon is burned in the presence of oxygen the carbon : when carbon is burned in the presence of oxygen the carbon and oxygen combine to produce carbon dioxide. if you start
Estimate the mass of water that must evaporate from the : evaporating sweat cools the body because evaporation is endothermic and absorbs 2.44 per gram of water evaporated.
A symmetric compound channel in over bank flow has a main : a symmetric compound channel in over bank flow has a main channel with a bottom width of 30 m side slopes of 11 and a
Calculate the molar mass of the biomolecule for carbon : a 2.30-g sample of a large biomolecule was dissolved in 16.0 g of carbon tetrachloride. the boiling point of this
A steel cylinder holds 160 g of ethanol c2h5oh what is the : a steel cylinder holds 1.60 g of ethanol c2h5oh. what is the pressure of the ethanol vapor if the cylinder has a volume
Two streams discharge into a pipe as shown flows are : two streams discharge into a pipe as shown flows are incompressible. the volume flow rate of streams into the pipe is
If you place 7gt50 mg of xecf32 into a flask how long must : the compound xecf32 decomposes in a 1st order reaction to elemental xe with ahalf-life of 30. min at room temperature.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Atual discharge of a water pipeline

If the elevation difference between the water surfaces is y = 25 + x/11 metres, what minimum pipeline diameter will be required to convey the design discharge? Once your design is complete, determine the actual discharge. The value of x equals 23.

  What textbooks are used and required

What textbooks are used and required for CIVE 205, MECH 289, CIVE 290, EPSC 221 and MATH 263 at McGill?

  Determine the total resultant force

in inclined circular gate with water on one side shown in the figure. determine the total resultant force acting on the gate and the total location of center pressure.

  What is the name of the text book and author used

What is the name of the text book and author used for thr course CEE30 in the spring quarter of 2013, at University of California Irvine?

  Determine the wattage of the fan-motor unit to be purchased

A fan is to be selected to ventilate a bathroom whose dimensions are 2 m x 3 m x 3 m. The air velocity is not to exceed 8 m/s to minimize vibration and noise. The combined efficiency of the fan-motor unit to be used can be taken to be 50 percent.

  Determine flow rate of water that will cause a pressure drop

Determine the flow rate of water (20 degrees celcius) that will cause a pressure drop of 17250 N/m^2 in 350m of horizontal, cast-iron pipe (d=60cm). assume minor losses are negligibe

  Find yield strength for factor of safety of with deformation

During the manufacturing process, a circular steel bar of diameter20mm and length of 1.2m is subjected to an axial load P. Themodulus of elasticity of steel is 207 GPa. The steel bar mustacquire an elastic strain energy of 14J.

  Supervisors technicians and skiled workers in dangerous work

As a project manager on site where work for 3 km long tunnel has been undertaken the site is remote and takes about 2 days to travel to nearest town supervisors technicians and skiled workers in dangerous work.

  Determine the pumping power required to produce of water

In an irrigation system sometimes water must be pumped over long distances. Consider a system that consistes of a 1 m diameter, 2 km long commercial steel pipe, which connects a river to an irrigation canal.

  Determine how many molecules of h20 is the system

A piston cylinder contains 0.8kg of steam (water vapor) at 300 deg C and 1MPa absolute. The steam is cooled at constant pressure until half of the mass condenses.

  How much will bar deform if it is released from the framwork

A 24-in.-long copper bar with a yield strength of 30,000 psi is heated to 120°C and immediately fastened securely to a rigid framework. The coefficient of thermal expansion for copper is 16.6x10-6 (1/oC).

  What constant gas pressure is required of the area

a 2kg piston accelerates to 20m/s from rest. what constant gas pressure is required if the area is 10cm^2, the travel is 10cm and the outside pressure is 100Kpa

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd