What kinds of pipes are used for steam lines, Mechanical Engineering

Assignment Help:

Normally galvanized pipes are not used for steam. Mild steel with screwed or welded fittings are the norm. Pressure and temperature are very significant factors to be considered in what type of materials to be used. Steam even at low pressures can be extremely unsafe.

 


Related Discussions:- What kinds of pipes are used for steam lines

Determine about the extent of excavation, Determine about the extent of exc...

Determine about the extent of excavation The extent of excavation depends upon the construction problems like dewatering and uplift. In extreme cases anchoring of the box may b

Clearence, what is clearance?what is the need of clearance?differences betw...

what is clearance?what is the need of clearance?differences between with clearance and with out clearance?

What are types of raft foundation, What are types of raft foundation? Defin...

What are types of raft foundation? Define according to rigid mat deign. One of the common types of raft foundation is the flat concrete slab 0.75 to 2.00 m thick with a two way

Heat transfer, an elctric current is passed through a wire 1mm in diameter ...

an elctric current is passed through a wire 1mm in diameter and 10mm long. the wire is submerged in liquid water at atmospheric pressure and current is increased until the water bo

Define the binary vapour cycle, Write brief notes on the following : (a)...

Write brief notes on the following : (a) Draught System (b) Binary Vapour Cycle (c) Cooling Towers (d) Governing of steam turbines

Question, A28) cm diameter pipe carries oil of sp. gr. 0.9 at a velocity of...

A28) cm diameter pipe carries oil of sp. gr. 0.9 at a velocity of 3 m/s . At another section diameter is 20 cm. find the velocity at this section and also mass rate of flow of oil.

Compare otto cycle with diesel cycle, Compare otto cycle with Diesel cycle:...

Compare otto cycle with Diesel cycle: Sol.: These two cycles can be compared on the basis of either the same compression ratio or the same maximum pressure and temperature.

Mechanical data for line designation tables, Line Designation Tables (LDT's...

Line Designation Tables (LDT's) (Appendix "D") are initially generated by the Piping designers. Design conditions are inputed by the Process discipline, and the Mechanical Engineer

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd