What is microprocessor, Electrical Engineering

Write short notes of the following.
a)    Microprocessor
b)    Modes of data transfer.
c)    I/O processor
d)    Associative memory
e)    Software and Hardware interrupt

Posted Date: 3/12/2013 5:41:14 AM | Location : United States







Related Discussions:- What is microprocessor, Assignment Help, Ask Question on What is microprocessor, Get Answer, Expert's Help, What is microprocessor Discussions

Write discussion on What is microprocessor
Your posts are moderated
Related Questions
Q A beam containing two types of charged particles is moving from A to B. Particles of type I with charge +3q, and those of type II with charge -2q (where -q is the charge of an el

(a) Show Diode as a half wave rectifier. Determine efficiency and Ripple factor of the half wave rectifier. (b) Write short note on LED. Briefly explain : (i) Positive cli

Q. Explain with the help of a circuit diagram,the operation of COLPITTS OSCILLATOR. Oscillator is a circuit used to generate a.c voltage without a.c.input signal.The energy to

Q. A JK flip-flop is shown in Figure (a). (a) Modify it to operate like the D flip-flop of Figure (b). (b) Modify the JK flip-flop to operate like the T flip-flop of Figure (

Discuss the function of instruction queue in 8086? In 8086, a 6-byte instruction queue is presented at the Bus Interface Unit (BIU). It is used to pre fetch and store at the ma


MODULE 2 EXERCISE: OP-AMP CONFIGURATION

In practice, it is usually better to wind the field coils on the rotor and supply the field current to them via slip rings.  As the rotor turns, the changing magnetic field expe

A relay is essentially an electromechanical switch that opens and closes electrical contacts. A simplified relay is represented in Figure. It is required to keep the fenomagnetic p

Calculate the maximum length of an optical fibre that exhibits 0.8dB/km attenuation if the optical output is 10mW and the power launched at the input is 150mW. [Hint: Loss, L=10 lo