What are encoder and the decoder, Electrical Engineering

There are zillions of things in electronics known as encoders. You can look up LCDs and NAND gates as well and this is actual basics.   

 

 

Posted Date: 4/6/2013 2:39:29 AM | Location : United States







Related Discussions:- What are encoder and the decoder, Assignment Help, Ask Question on What are encoder and the decoder, Get Answer, Expert's Help, What are encoder and the decoder Discussions

Write discussion on What are encoder and the decoder
Your posts are moderated
Related Questions
Discuss important properties and uses of Mica and Mica Products. Mica and Mica Products - Mica is an inorganic material. This is one of the best insulating materials availa

Fixed bias (base bias): Diagram: Fixed bias (Base bias) This type of biasing is also known as  base bias . In the instance above figure, the single power source (

READY Input Microprocessor  has to communicate with other  peripherals which  are slow  as compared to the microprocessor. READY  signals  is used to synchronies  these periphe

Switched Mode Power Supply  (SMPS) Switching mode power  supply converts an unregulated DC voltage  to a regulated DC  output  voltage . SMPS  stands  for switched mode  power

Consider an S band (3 GHz) radar with a rotating aperture antenna with a width of 3 m.  Suppose the antenna rotates at a rate of one rotation every 10 seconds.  Assume the 3 dB bea

The distribution transformer is supplying a load at 240 V and 0.8 power factor lagging. The open-circuit and short-circuit test data are given in Example. (a) Determine the frac

Explain the basic working principle of ultrasonic machining with the help of diagram. What are the different kinds of tool materials explain, tool holders are used in ultrasonic

Classify plastic materials into two categories describe their important properties and give two examples of each. Plastic materials can be categorized in thermoplastic and ther

Circuit Symbols for MOSFET A range of symbols are employed for the MOSFET. The basic design is usually a line for the channel along with the source and drain leaving it at rig

Comparison with vacuum tubes: Prior to the growth of transistors, vacuum (electron) tubes (or in the UK (United Kingdom) "thermionic valves" or just "valves") were the major a