Water and Wastewater Treatment, Chemical Engineering

this is my assignment '' Disinfection of water streams originating from potable water plants is key in protecting
environmental health. Describe the process design and application, along with potential
processing advantages, limitations and disadvantages of using: (i) chlorination; (ii) UV light;
(iii) ozonation, and (iv) crossflow membranes to disinfect potable water from a municipal
plant.
Your report should be fully referenced within the text, including any pictures or diagrams
used, and include an Abstract at the beginning (no more than 8 lines). The Abstract
should be followed by an Introduction, then four individual Sections (one per
disinfection method). Follow these sections with a separate section that discusses when
a combination of methods may be needed.
Finally, include a Conclusion section that provides an overall discussion of the key
points arising from the entire report. The Conclusions should be no more than one
page. Also make sure you include at the end of the report a list of all References used
in the text.
On-line encyclopedias, such as Wikipedia, are not adequate as a reference - you must
quote the original source (e.g., journal article, book, technical report etc.). ''

and i attached the full assignment also

i need this assignment to be between 10-12 pages
font 11 Arial
need some graphs and pictures if possible
and i want it free plagiarism
and the sources should be academic like books or journals
NO wikipedia ALLOWED PLEASE
References and Abstract needed
THIS IS AN ENGINEERING COURSE SO I DONT KNOW IT I PUTTED IT IN THE RIGHT Catalog
Posted Date: 10/12/2012 2:59:13 AM | Location : United States







Related Discussions:- Water and Wastewater Treatment, Assignment Help, Ask Question on Water and Wastewater Treatment, Get Answer, Expert's Help, Water and Wastewater Treatment Discussions

Write discussion on Water and Wastewater Treatment
Your posts are moderated
Related Questions
Which one of the following statements is correct? You may wish to examine a molecular model of this compound. 1. Carbon D is an asymmetric center and its configuration is R 2

The aim of this assignment is to develop and test your ability to integrate your knowledge of plastic failure and fracture. Below is a plot that shows the plane strain fracture tou

Your favorite professor likes mountain climbing, so there is always a possibility that the professor may fall into a crevasse in some glacier. If that happened today, and the profe

The property of a material by which it can be drawn into wires is called as  Ductility is the only property of a material by which it can be drawn into wires.

An operator tells you that it takes 2 minutes for a process to get half way to the final value after a step change in the input. What can you infer about the process time constant

What are the chief characteristics of ferro-electric materials Ferroelectric materials have following characteristics: a)  They have a huge dielectric constant which is non-

The most common DC applications are: Electromagnets and yokes • Relays  • Magnetic shields  • Electrical measuring devices  • Magnetic amplifiers

Objectives After doing this exercise you should be able to: 1. Describe the features of the preparation room of the lab you have visited, 2. Examine and evaluate a prepar

What is the aim of shear stress distribution?

For a given bulk solid how can the particle size distribution be determined? In order to determine particle size distribution the simplest method is to make use of a sieve stac