Vectors or matrices matlab, engineering, Other Engineering

Vectors or matrices

MATLAB can make and operate arrays of 1 (vectors), 2 (matrices), or more measurements. In the MATLAB language, a vector represents a one perspective (1×N or N×1) matrix, known as a range in other selection dialects. A matrix usually represents a 2-dimensional range, i.e. a man range where m and n are higher than 1. Arrays with more than two measurements are called multidimensional arrays.

Array operations solutions with matlab assignment help

 Arrays are an essential type and many conventional features natively support range features enabling work on arrays without precise circles. Therefore the MATLAB terminology is also an example of range selection terminology.

A simple array is mostly defined with using the syntax: init: increment: terminator. With easy illustration:

>> Array = 1:2:9

Array = 1 3 5 7 9

Range with matlab assignment help 

In matlab, Describes a diverse known as range (or assigns a new value to a current diverse with the name array) which is a range made up of the 1, 3, 5, 7, and 9. That is, the range begins at 1 (the init value), amounts with each phase from the past value by 2 (the rise value), and prevents once it actually grows to (or to prevent exceeding) 9 (the terminator value).

>> Array = 1:3:9

Array = 1 4 7

Posted Date: 2/17/2012 3:29:48 AM | Location : United States







Related Discussions:- Vectors or matrices matlab, engineering, Assignment Help, Ask Question on Vectors or matrices matlab, engineering, Get Answer, Expert's Help, Vectors or matrices matlab, engineering Discussions

Write discussion on Vectors or matrices matlab, engineering
Your posts are moderated
Related Questions
The centre of pressure (CP) is defined as the point about which the resultant moment is zero; the net effect of the flow in terms of forces and moments would be the same as if the

1. A very narrow laser beam in air is shone into a sphere of solid glass that has a uniform refractive index n>1 and radius ? . The beam makes an angle a in air with the normal to

Casting Alloys are -             (i) Permanent moulds are commonly used for the casting of grey iron, aluminum alloys and magnesium alloys.             (ii) Slush Casting

The module content and teaching style has undergone revision since 2006-07. There are two reasons for this. First, this was the first year that Prof Badcock was responsible for the

ENGINE CYCLES The two commonly used cycles on which the I.C. engines operate are: 1Otto cycle.         2 Diesel cycle. 1 OTTO CYCLE: theoretical Otto cycle is shown i

advantages and disadvantages oh hot and cold die working in the subject of basic mechanical engineering

A 50 cm  diameter pipeline in the Arctic Carries hot oil at 30 0 C and exposed to a surrounding temperature of -20 0 C. Special powder insulation 5 cm thick surrounds the pipe an


load flow analysis by fast decoupled method

What are the no-arbitrage lower bound, and the no-arbitrage upper bound, of the vertical spread c(k1)-c(k2)?