Types of couple - mechanics, Mechanical Engineering

Types of couple:

Explain about different types of couple?

 Sol.: There are mainly two types of couples:

1. Clockwise Couple

 

1004_types of Couple.png

A couple whose tendency is to rotate body, on which it acts, in clockwise direction, is called as a clockwise couple. Such a couple is called as positive couple.

 

1004_types of Couple.png

2. Anticlockwise Couple

A couple whose tendency is to rotate body on which it is acting, in anticlockwise direction is called as anticlockwise couple. Such a couple is called as Negative couple.

 

1347_types of Couple1.png

Posted Date: 10/17/2012 2:46:32 AM | Location : United States







Related Discussions:- Types of couple - mechanics, Assignment Help, Ask Question on Types of couple - mechanics, Get Answer, Expert's Help, Types of couple - mechanics Discussions

Write discussion on Types of couple - mechanics
Your posts are moderated
Related Questions
Find out the quality: ABC industries manufacture X-band radar scanners utilized to detect speed traps. The printed circuit boards in the scanners are bough from an outside ven

A single jet pelton wheel runs at 300 rpm under a head of 510 m. the jet diameter is 200m, its deflection inside the bucket is 165 o and its relative velocity is reduced by 15% be

Q. Describe Cold extrusion? • Cold extrusion is done at room temperature or near room temperature. • The advantages of this over hot extrusion are the lack of

Slip-On Flanges Slip-on flanges are limited to use under the following conditions: ASME/ANSI B16.5 standard forged flanges for design pressures and coincident temperatures n

METAL TRANSFER The continuously fed electrode wire is melted in the arc heat and the droplets thus formed at the wire tip are transferred to the weld pool. The way in which mater

Ask question #MiThe steam that leaves the super-heater is expanded from 130bar at 535°C to 25.2bar at 310°C in a high pressure turbine. The steam from the exit of the HP turbine is

What is bending stress? The bending moment at section tends to bend or deflect beam and internal stresses resist its bending. The process of bending stops when the cross sectio


Explain Numerical Control (N.C) Procedure a) Process Planning: - This is listing of the sequence of operation to be performed during manufacturing of a part. This as well lists

Define the Effect of Feed Increase in feed rate deteriorates surface finish. It is observed that a rate of feed in the range from0.12 to 0.15 mm per revolution has a negligible