Transparent latch d flip flop, Electrical Engineering

Transparent latch D flip  Flop

A typical  example  of this  type of D flop  is 7475 shown  in figure when CLK  connected is enable signal is high and the flip  flop  is enabled. During   this period ( until CLK  is high)  the output  changes according to input.

Posted Date: 4/4/2013 12:59:45 AM | Location : United States







Related Discussions:- Transparent latch d flip flop, Assignment Help, Ask Question on Transparent latch d flip flop, Get Answer, Expert's Help, Transparent latch d flip flop Discussions

Write discussion on Transparent latch d flip flop
Your posts are moderated
Related Questions
What is RXD? RXD- Receive Data Input This input pin of 8251A gets a composite stream of the data to be received by 8251A.

Q. A signal with bandwidth of 100 MHz is to be transmitted 40 km by LOS radio transmission. Taking B/fc = 1/30, and using a circular-aperture parabolic dish with 50-cm radius at ea

Questions: Part (a) A compressor installed at a wharf (for loading container ships) is able to provide 6 bar.g pressure into the pressure receiver. The compressor is moved

Q. Do the following operations with 8 bit bytes, and indicate the condition of the overflow and carry bits. a) 10111011 + 00000011 b) 11101101 + 11111001 c) 11011011 + 110

Aplication of resonance in different divices

RESETIN  Input It is an  active  low signal when  it goes low program counter is  reset to zero and busses are tri stated  it also reset interrupt enable flip flop  and instruc

Power up the "TIMS" unit by using the switch at the back. Connect the Pico Virtual Instrument (PicoScope) to the PC as per Appendix 1 On the "TIMS" unit, connect the 2 kHz (s

Consider the network shown in Figure containing a voltage-controlled source producing the controlled current i c = gv, where g is a constant with units of conductance, and the con

A 6 V / 2.5 mA relay is connected in the output stage of a transistor.  The coil is made of aluminium having α = 0.004. The resistance of the coil is 600 ? at 32 o C. Calculate th

Define and explain Numerical aperture? Figure shown below shows an incident ray to the fibre, The light bends at two interfaces, one at the air- core interface and the