transformer, Electrical Engineering

A6KVA,100V/500V single-phase transformer has a secondary terminal voltage of 487.5 volts when loaded. determine the regulation of the transformer
Posted Date: 9/2/2013 9:54:30 AM | Location : Botswana







Related Discussions:- transformer, Assignment Help, Ask Question on transformer, Get Answer, Expert's Help, transformer Discussions

Write discussion on transformer
Your posts are moderated
Related Questions
Question 1: a) Describe how pipelining can improves the efficiency of the fetch-execute cycle. b) Explain the term superscalar architecture. c) Explain the term prin

Q. Explain Mesh - Current Method? This complements the nodal-voltage method of circuit analysis. A set of independent mesh-current variables that implicitly satisfy the KCL equ


Explain the ASSUME assembler directive with example ASSUME: It will be used to map the segment register names along with memory addresses. The Syntax is as g

Assembly Languages  ( Second Generation Language) To overcome  the difficulty of machine  language assembly  language  was  designed. After  facing the  difficulty of machine

Q. Two identical junction diodes whose volt-ampere relation is given by Equation in which IS = 0.1 µA, VT = 25 mV, and η = 2, are connected as shown in Figure. Determine the curren

Q.  A shunt generator gives full load output of 30 kW at a terminal voltage of 200V. The armature and field resistance are 0.05? and 50? resp.. The iron and friction losses are 10

Half-wave rectifier: A half-wave rectifier will just only give one peak per cycle and for this reason and other reasons is only employed in extremely small power supplies. A f

Critical Rate of  Rise of Current The maximum  rate of  increase of current  during  on state  which  the SCR  can tolerate is called  the critical rate of rise  of current  f

For the circuit of Fig: (i) using Kirchoff's Laws , find all the currents (ii)  determine the voltage across each resistor and check that all loops comply with KVL (iii