THERMODYNAMICS, Mechanical Engineering

what is second law of thermodynamics
Posted Date: 8/18/2012 2:17:25 PM | Location : United States







Related Discussions:- THERMODYNAMICS, Assignment Help, Ask Question on THERMODYNAMICS, Get Answer, Expert's Help, THERMODYNAMICS Discussions

Write discussion on THERMODYNAMICS
Your posts are moderated
Related Questions
Relationship between two specific heat ? Sol:   dQ = dU + dW; for a perfect gas dQ at constant pressure dU at Constant volume; = mC v dT = mC v (T 2  - T 1 ) dW at

PART A A new process plant for ore processing is currently being planned. The design is only in the first stage. However, three requirements have already been clearly stated:

Q. Lap-Type Flange-To-Shell Clearance? Lap-Type Flange-To-Shell Clearance The difference between the flange ID and the shell OD shall not exceed: • 1/16 in (1.6 mm) for n

Conve r t following reading of pressure to kPa, supposing that the barometer reads 760mm Hg. (1) 90cm Hg gauge (2) 40cm Hg vacuum (3) 1.2m H 2 O gauge Sol: Given

Find the minimum weight to keep equilibrium: A belt supports the two weights W 1 an d W 2 over a pulley as shown in the figure given below. If W 1 = 1000N, fi

Keywords: Degree of Curve      :            The angle subtended at the centre by a chord of 100 ft (30.5 m) length. Super-elevation (cant)        :            The raising

(a) What are the basic conditions for a body to be in state of equilibrium? (b) Two steel cylinders of similar diameter are supported in a rectangular vessel. The width of the v

(a) Draw a single point cutting tool and label clearly the several parts of it. Illustrate them in brief. (b) What are the several factors affecting tool life ? (c) List char

Branches of mechanics: Mechanics is basically divided in to two parts Static's and Dynamics, Dynamics is further divided in kinematics and kinetics Statics: It deals with

Austempering: The component to be hardened is initialy austenised and after that quenched into a lead or salt bath held at just over the martensite transformation temperature