question.A , Civil Engineering

#q
strain gauge arrangement is used to measuuestion..
Posted Date: 1/23/2013 1:20:23 PM | Location : Sri Lanka







Related Discussions:- question.A , Assignment Help, Ask Question on question.A , Get Answer, Expert's Help, question.A Discussions

Write discussion on question.A
Your posts are moderated
Related Questions
classification of foundation

State the term - Stresses from concrete to reinforcement Stresses from concrete to reinforcement, or vice-versa, in reinforced concrete are transferred due to bond between conc

chlorosis in plants is caused by

Vibrocoring in marine ground investigation If only shallow marine ground geotechnical information is essential for design purpose, vibrocoring is certainly a good choice for s

Q. Earth work in high embankments? (a) Borrow pits must not be dug close to telegraph poles, electric poles, level crossings, bridges a culverts, or within 800 meters of the bo

Steel triangulated (open web) girders are provided with camber to compensate for deflection under load. Out of the total design camber, the part corresponding to dead load is calle

Q. What do you mean by Piston sampler? In sampling silts orclays, Piston sampler is lowered into boreholes and piston is locked at bottom of the sampler. This stops debris from

A square pile group of 9 piles of 25 cm diameter is arranged with a pile spacing of 1m. The length of the piles is 9 m. Unit cohesion of the clay is 75 kN/m 2 . Neglecting beari

Road Location in Dune Areas: The following principle should be observed in locating a road in dune areas : (a) Align a road where sand is covered by vegetation. (b) Sel

Two crops are grown on land of 20ha.The cost of raising crop 1 is 3unit/ha, while for crop 2 it is 1 unit/ha.The benefit from crop 1 is 5unit/ha and from crop 2, it is 2 unit/ha. A