material technology, Mechanical Engineering

what is the normalizing of steel
Posted Date: 3/18/2013 3:58:04 PM | Location : Ghana







Related Discussions:- material technology, Assignment Help, Ask Question on material technology, Get Answer, Expert's Help, material technology Discussions

Write discussion on material technology
Your posts are moderated
Related Questions
Find maximum torque which can be transmitted by belt drive: A belt is stretched over the two identical pulleys having diameter D meter. The initial tension in belt throughout

Quality Improvement : CAD can improve the quality of engineering design by increasing the efficiency and effectiveness of the designers. This can be observed with excellent

Name The Boolean Set Operators used in CSG The Boolean Set Operators used are : union : A + B is the set of points that are in A or B. intersection : A . B is the s

Q. Properties of plastic? Their great variety of physico- chemical and mechanical properties, and ease with they can be made into various articles have found plastic their wide

Evaluate Elongation of wire: An aerial copper wire ( E =1 x 10 5 N/m m 2 ) 40 m long is having cross sectional area of 80 mm 2 and weighs 0.6 N per meter run. I

Remove cover left crank case and check for leakage: Before attending oil seal leakage check if any leak is there in the highlighted points - Neutral switch "o" ring leak, Shifter

It is desired to produce an iron-carbon alloy that has a minimum hardness of 200 HB and a minimum ductility of 35%RA. Is such an alloy possible? If so, what will be its composition

Qusetion: A body when projected vertically up covers a total distance s, during its time of flight. If we neglect gravity then how much distance, the particle will travel during

Computers control system in flexible manufacturing system

The three prototyping methods used are: a)  R a p i dPrototyping: This is used to model the pins (large 1, 2 and small), lock disk and crank. b)   CNCMachining: Use