Manufacturing , Mechanical Engineering

Differentiate between hot working and cold working process
Posted Date: 3/9/2013 3:14:03 AM | Location : Anonymous Proxy







Related Discussions:- Manufacturing , Assignment Help, Ask Question on Manufacturing , Get Answer, Expert's Help, Manufacturing Discussions

Write discussion on Manufacturing
Your posts are moderated
Related Questions
Uniformly Varying Load - support reaction: Uniformly Varying Load: In the diagram load varying from Point A to point C. The intensity of it is zero at A and 900N/M at C. Her

In general, gear drive is useful for power transmission among two shafts, which are near to each other (at most at 1m distance). In addition, it has maximum efficiency whereas tran

differentiate between scalar and vector quantities?

Flow work: Flow work is energy possessed by the fluid by virtue of its pressure. Displacement Work: When piston moves in cylinder from position 1 to 2 with vo

what are the necessery calculation required to design a gripper?

Q. What do you mean by Bunds and Dikes ? A bund (or dike) is an embankment or wall of brick, stone, concrete or other impervious material, which surrounds the entire perimeter

Dead Centre The position of the working piston and the moving parts which are mechanically connected to it, at the moment when the direction of the piston motion is reserved

Consider radar with a PRF of 5 kHz. What is the maximum unambiguous range R ua of this radar, in km?  If a target is located at a range of 50 miles, how many pulses will the r

i am thinking that neglecting the foot gears and put hand gears instead of it in two wheelers .so what is the procedure

for a circle,is the net work necessarily zero? for what kind of system will this be the case?