foundry, Mechanical Engineering

properties of moulding sand
Posted Date: 3/10/2013 10:25:43 PM | Location :







Related Discussions:- foundry, Assignment Help, Ask Question on foundry, Get Answer, Expert's Help, foundry Discussions

Write discussion on foundry
Your posts are moderated
Related Questions
Q. Preliminary layout considerations? This section outlines the key aspects to be considered when preparing preliminary layouts during the evaluate phase. Preliminary layouts a

Design a hydrocooling unit that can cool fruits and vegetables from 30 to 5 degrees Celsius at a rate of 20,000 kg/hr under the following conditions: The unit will be of flood typ

Motion of two bodies - Smooth surface and smooth pulley: THE HORIZONTAL SURFACE IS SMOOTH AND STRING IS PASSING OVER SMOOTH PULLEY: Figure shows two weights W 1 and W 2 c

Illustrate the assumptions made in Euler's theory. Determine the expression for crippling load for a long column when one end of the column is fixed and other end is hinged.

Thermal efficiency and compression ratio: Calculate thermal efficiency and compression ratio for automobile working on otto cycle. If energy generated per cycle is thrice whi

Estimate temperature of air at exit from compressor: The air compressor compresses atmospheric air at 0.1MPa and 27 0 C 10 times the inlet pressure. During compression heat

A system consisting of 2kg of R-134a undergoes a cycle composed of the following processes: Process 1-2: constant volume from P1= 10 bar, x1=0.6 to saturated vapor. process 2-3 con

Determine reactions force: Thr e e sphere A , B and C weighing 400N, and 200N and having radii 400mm,  600mm and 400mm respectively are placed in trench as shown in t

validity on compressible and incompressible fluids

Give the working and consideration of a diaphragm spring single plate clutch in disengaged position. Discuss in detail the constructional features of a clutch plate. Explain the