Customer Service Chat
Get quote & make Payment
door strap pull force, Mechanical Engineering
A pull up door is stuck in the closed position. A strap, fastened on the inside bottom and located at the center of the door is pulled outward at an angle of 45 deg above horizontal in attempt to raise it. A rubber door seal is on the bottom of the door and the strap passes under that seal so that the force is outward. The coef. of friction measures .52 between the seal and the strap. How much does the friction force detract from the force the strap feels at its fastener?
Posted Date: 11/14/2012 3:52:30 PM | Location : United States
Ask an Expert
door strap pull force, Assignment Help, Ask Question on door strap pull force, Get Answer, Expert's Help, door strap pull force Discussions
Write discussion on door strap pull force
Your posts are moderated
Write your message here..
Calculation of seismic response loads, Q. Calculation of seismic response l...
Q. Calculation of seismic response loads? The seismic design requirements and the specification of criteria variables for the calculation of seismic response loads for the desi
Friction is desirable, Friction is Desirable: A friction is much de...
Friction is Desirable: A friction is much desirable to stop the body from its moving condition. If there is no friction between contact surfaces, then the body cannot be st
Pendulum pump mechanism, describe about pendulum pump mechanism and dia...
describe about pendulum pump mechanism and diagram
Boiler, boiler water hammering
boiler water hammering
Identification of pressure welds, Q. Identification of Pressure Welds? ...
Q. Identification of Pressure Welds? Pressure welds shall be identified as follows: a. Generally each weld shall be stamped adjacent to the weld with the welder's identity c
Applied chemistry, hardness of bore well water is less than sea water .just...
hardness of bore well water is less than sea water .justif
Define pattern draft or taper, Q. Define Pattern draft or taper? It is ...
Q. Define Pattern draft or taper? It is also termed as "draw". It is the taper placed on the pattern surface that are parallel to the direction in which the pattern is withdraw
Module site installation preparation, Q. Module Site Installation Preparati...
Q. Module Site Installation Preparation? The following tasks shall be accomplished at the Facility site prior to setting the modules on the piles: After module support piles
Explain the side relief angle, Explain the Side Relief Angle It is angl...
Explain the Side Relief Angle It is angle made by flank of a tool and plane perpendicular to base just under the side cutting edge. if the side relief angle is very large the c
Control System, I have a project due in 20 hours and I need help please.
I have a project due in 20 hours and I need help please.
Accounting Assignment Help
Economics Assignment Help
Finance Assignment Help
Statistics Assignment Help
Physics Assignment Help
Chemistry Assignment Help
Math Assignment Help
Biology Assignment Help
English Assignment Help
Management Assignment Help
Engineering Assignment Help
Programming Assignment Help
Computer Science Assignment Help
Why Us ?
~24x7 hrs Support
~Quality of Work
~Time on Delivery
~Privacy of Work
Human Resource Management
Literature Review Writing Help
Terms & Conditions
Copyright by ExpertsMind IT Educational Pvt. Ltd.