i want help

Posted Date: 3/8/2012 10:17:26 PM | Location : United States

Ask an Expert

Related Discussions:- Design centrifugal pump, engineering, Assignment Help, Ask Question on Design centrifugal pump, engineering, Get Answer, Expert's Help, Design centrifugal pump, engineering Discussions

Write discussion on Design centrifugal pump, engineering
Your posts are moderated

Write your message here..

Related Questions

Combinational logic, multiplex cicurit multiplex cicurit

The integrator, Integrator This circuit performs the calculus operation... Integrator This circuit performs the calculus operation of integration. An operational amplifier with negative feedback applied via a capacitor (instead of a resistor) will pe

Uihuihuiui, jihjihjihjihuih jihjihjihjihuih

Find out the heat loss, A 3.6-cm inside diameter stainless steel pipe is be... A 3.6-cm inside diameter stainless steel pipe is being used to convey a liquid food. The inside convective heat-transfer coefficient is 10 J/s.m2. o C. The pipe is 0.5 cm thick and

Crystal imperfection, Q.   What is crystal imperfection? Briefly discuss ... Q.   What is crystal imperfection? Briefly discuss all types of point defects in crystals. Ans. The various type of crystal imperfection are as follows: (1)   Point de

Shelf list filing - library management, Shelf List Filing   Shelf list ... Shelf List Filing   Shelf list reflects the arrangement of documents in the library. That is to say, the classificatory arrangement of the documents in a library can be seen th

Aeroengine - axial flow compressor , An axial-flow air compressor consists ... An axial-flow air compressor consists of 10 rotor/stator stages each built from p gblades of identical cross-section and designed such that the axial velocity is constant throughou

Heat and mass transfer, attachment attachment

Nozzle guide vane inspection, Nozzle Guide Vane Inspection: Inspection ... Nozzle Guide Vane Inspection: Inspection of the NGVs is possible using a strong light source and mirror, it is more probable however that a boroscope inspection will be require

Spot welding, In spot welding, the parts to be joined are normally over lap... In spot welding, the parts to be joined are normally over lapped. The work piece are clamped between two water cooled copper electrodes. On the passage of a high transient current,