casting, Mechanical Engineering

defect of casting
Posted Date: 4/5/2013 4:49:51 PM | Location : Ethiopia







Related Discussions:- casting, Assignment Help, Ask Question on casting, Get Answer, Expert's Help, casting Discussions

Write discussion on casting
Your posts are moderated
Related Questions
Define Supports Pins and Jack Pins When the work is clamped directly in the body of the jig or fixtures, there is always a chance of error due to improper supports on accounts

Calculate total deflection -two close-coiled helical springs: Two close-coiled helical springs are compressed among two parallel plates by a load of 1000 N. The springs contai

(a) Describe and calculate i) Humidity Ratio ii) DPT iii) Relative Humidity iv) Density v) Enthalpy of atmosphere air when DBT is 35 0 C, WBT is 23 0 C and the ba

A tensile test on a specimen having an initial diameter of 13.11 mm and an initial gauge length of 200.0 mm, gave the following data:

The density of a sample of oak is 0.90 g/cm^3. Calculate             a. the density of completely dry oak             b. the percent water in the original sample

CLASSIFIC A TION :  The steam turbines can be classified as follows: 1 .     In accordance to method of steam expansion: (a) Impulse   (b) Reaction. 2 .     In

System of parallel forces: A rigid body is subjected to system of parallel forces as shown in the figure. Reduce this system to, ( i ) A single force system ( i

a beam ABC is simply supported at A and C and caries a couple equal to 100kN applied clockwise at B

Determine the centroid of the area: Determine the centroid of the area OBDC Solution The trapezium area is divided in two simple areas,  (i)        A 1 = Rectangle