Matlab code, Electrical Engineering

Linear Equalizer and Decision Feedback Equalizer
Simulation and Performance Comparison
In this project , performance of decision feedback equalizer is analyzed, simulated and compared with that of linear equalizer for a given channel model. In doing this the project should mainly focus on the superiority of the decision feedback equalizer over linear equalizer in the sense that the MSE of DFE is close to the noise floor , while that of LE is bounded to Le bound .Of course , this true only when SNR is high enough such that decision error is small.
Posted Date: 12/13/2012 1:59:39 PM | Location : United States







Related Discussions:- Matlab code, Assignment Help, Ask Question on Matlab code, Get Answer, Expert's Help, Matlab code Discussions

Write discussion on Matlab code
Your posts are moderated
Related Questions
Define and explain Numerical aperture? Figure shown below shows an incident ray to the fibre, The light bends at two interfaces, one at the air- core interface and the

With respect to serial communication define the parity. Besides the synchronization given by the use of start and stop bits, an additional bit termed as a parity bit may opt

filt is a circuit that cantains onely passive components

Q. Advanced Mobile Phone System? Cellular systems employed cells with a radius in the range of 5-18 km. The base station usually transmitted at a power level of 35 W or less, a

A battery having of five cells in series. Each cell is 2.5V and internal resistance is 0.05 Ω. A battery is linked to the load resistance of 15Ω. Verify: i.  Total e.m.f

Q A60-Hz, 100-kVA, 2400/240-V(rms) transformer is used as a step-down transformer from a transmission line to a distribution system. Consider the transformer to be ideal. (a) Fi

Q. Explain the different coupling schemes used in amplifiers? When amplifiers are cascaded, it is necessary to use a coupling network between the output of one amplifier and th

The conditions necessary for sustained oscillation can be summarized as follows: 1. There should be a positive feedback. 2. The loop gain of the circuit must be equal to or g

A balanced three phase, four wire, WYE connect load consisting of per phase resistenance of A ohms and inductive reactance of D ohms/phase is connected to a B000 V three phase sour