Three-phase Portable Bench Power Supply, Electrical Engineering

hi can you help me to create a dc to 3 phase ac circuit which can exceed at any point: 50V and 20A and 400W maximum. The output should be variable from about 0 – 25V per phase, with about 5A per phase available.
Posted Date: 10/19/2012 2:24:33 AM | Location : United States







Related Discussions:- Three-phase Portable Bench Power Supply, Assignment Help, Ask Question on Three-phase Portable Bench Power Supply, Get Answer, Expert's Help, Three-phase Portable Bench Power Supply Discussions

Write discussion on Three-phase Portable Bench Power Supply
Your posts are moderated
Related Questions
The interrupt vector table is always created in the first 1K area of the memory. Justify the statement. While the CPU receives an interrupt type number start from the PIC, this

Q. Write short note on Quantization? Quantization: This is first step in PCM. Total amplitude range of the modulating signal is divided into a number of standard levels calle

#What are the types of Negative Feedback Amplifier?

Electromagnetic torque  The torque is given by the force on the armature winding multiplied by its radius. Force on a conductor in magnetic field B is:  F=B.I.L so, T=B

Explain the TEST instruction. TEST: The TEST instruction executes the AND operation. The difference is as the AND instruction changes the destination operand, whereas the TEST

What is extended data output RAM? EDO RAM: A slight modification to the DRAM structure changes the device in an EDO (extended data output) DRAM device. Inside the EDO memory, a

Transparent latch D flip  Flop A typical  example  of this  type of D flop  is 7475 shown  in figure when CLK  connected is enable signal is high and the flip  flop  is enabled

1- Phase Full  Bridge  inverter will RL Load For a  resistive load R the load  current  wave form  will be  identical with load  voltage wave form  and feedback  diodes will

Draw the phasor diagrams for an RLC series circuit supplied by a sinusoidal voltage source with a lagging power factor and a GLC parallel circuit supplied by a sinusoidal current s

Question : (a) List the six basic quantities and units as used in the SI systems of units and give their respective symbols (b) A flux density in the CGS system is expressed