thermodynamics, Mechanical Engineering

get help
Posted Date: 8/15/2012 11:16:03 AM | Location : United States

Related Discussions:- thermodynamics, Assignment Help, Ask Question on thermodynamics, Get Answer, Expert's Help, thermodynamics Discussions

Write discussion on thermodynamics
Your posts are moderated
Related Questions
(a) A 50 mm dia. jet having a velocity of 18 m/sec. impinges without shock on a flat plate inclined at an angle to the axis of jet. If the plate is moving at 5 m/sec in the directi

how will u designate a v belt

The 70m microwave transmission tower is steadied by three guys cable. Cable AB carries a tension of 12kN. Express the corresponding force on point A as a vector

Flash Butt Welding The two pieces to be welded are pressed against each other by applying a pressure. To whatever finish the faces are machined, there will be some protuberance

Ratio of applied stress: What should be the ratio of applied stress, s, to yield stress s Y in a large thin plate so that plastic spread along lint of crack is equal to  1 /1

Is there a metal that does not contain iron? Ans) Most commercially available aluminum having some other materials, but only accidental traces of iron, if any. For example, Copp

A tensile test on a specimen having an initial diameter of 13.11 mm and an initial gauge length of 200.0 mm, gave the following data:

Advantage of flash butt welding 1. Higher weld strength 2. Higher production rate 3. Better heat concentration 4. Simple weld surface preparation 5. Wide range of m

The attached figure depicts an indirectly fired gas turbine engine. In the gas turbine engine, air is compressed to a high pressure and then heat is added. The high pressure, high

A simple Rankine cycle works between pressures 0.06 bar and 28 bar, the initial condition of steam being dry saturated. Determine the cycle efficiency, specific steam consumption a