#thermodynamics., Mechanical Engineering

#A spherical aluminum vessel has an inside diameter of 30 cm and contains water at 80 ?C, with a quality of 1%. The vessel is then heated until the water inside is saturated vapor. Determine the final temperature and pressure within the vessel.
Posted Date: 6/27/2012 11:58:23 AM | Location : United States







Related Discussions:- #thermodynamics., Assignment Help, Ask Question on #thermodynamics., Get Answer, Expert's Help, #thermodynamics. Discussions

Write discussion on #thermodynamics.
Your posts are moderated
Related Questions
Find the tangential and normal components of acceleration: A fly wheel along diameter 400 mm begins from rest with constant angular acceleration 2 rad/sec 2 . Find out the tan

Capacity Planning: This unit defined different ways to measure capacity, set up maximum capacity, and calculate capacity utilization. The long-term and short-term strategies t

1 Prepare a suitable system Memory Map over the first 3K of memory, a suitable PIO configuration and associated Z80 PIO initialisation words in order to support a single electro-hy

If Battery Discharges Frequently Causes of Problem Remedy Electrolyte specific gravity NG Charging not done fully

What is raft foundation? A raft or mat can be considered as a combined footing which covers the entire building area and supports all columns and walls. Such a foundation may c

Explain in detail about the Large excavations Large excavations required for construction of rafts may need dewatering, depending on the ground water flow and the choice of  a

Q. What is Transfer molding? Transfer molding was developed largely to avoid the disadvantages found which compression molding. • Transfer molding can make intricate or quit

Line of action of force: Sol.: The direction of force along the straight line through its point of application, in which force tends to move body to which it is applied. Thi

a) In strip rolling what is i) Forward slip ii) Neutral point. Illustrate with diagram. b) State the conditions for rolling.

State and define the bending equation and mention it''s units and derive it