The gage pressure reading on the pressure gage, Mechanical Engineering

The cylindrical tank with hemispherical ends shown in Fig. have volatile liquid and its vapor. The liquid density is 800 kg/m3, and its vapor density is negligible. The pressure in the vapor is 120 kPa (abs.) and the atmospheric pressure is 94 kPa (abs.). Determine,

(a) The gage pressure reading on the pressure gage.

(b) The height, h, of the mercury manometer.

290_33.png

Posted Date: 3/15/2013 2:10:56 AM | Location : United States







Related Discussions:- The gage pressure reading on the pressure gage, Assignment Help, Ask Question on The gage pressure reading on the pressure gage, Get Answer, Expert's Help, The gage pressure reading on the pressure gage Discussions

Write discussion on The gage pressure reading on the pressure gage
Your posts are moderated
Related Questions
Determine elongation of bar: A conical bar tapers uniformly from diameter of 4 cm to 1.5 cm in length of 40 cm. If axial force of 80 kN is applied at each end, determine elon

The Mechanical Engineer/Specialist shall prepare Material Requisitions for all required mechanical material and equipment. The format for all requisitions shall be in accordance w

how to find bending moment diagram of cantilever beam.any formula

Production management: In this Secetion, you have studied the introduction of production management. Functional units in an organization, features of production management and

The mass flow rate is 28kg/s in an axial flow gas turbine that develops 3.5MW. The stagnation conditions are 780KPa and 730 deg.C. at the entry. At the exit of the nozzle, the stat

Distinguish between microscopic and macroscopic approaches. Describe thermodynamic system. Differentiate between closed system, open system and an isolated system.

Principle of equilibrium: Sol.: Principle of equilibrium can be divided in to three main parts; (1) Two Force Principle: As the Resultant is zero when body is in equili

Q. What is Warm extrusion? • Warm extrusion is done above room temperature, but below the recrystallization temperature of the material the temperatures ranges from 424 to 975

Design of a Bicycle Frame : Figure  depicts a simple bicycle frame, which is to be built of hollow aluminium tubing with outside diameter of 20 mm and wall thickness of 2 mm. The f

Problems to improve the deficirncies of IGES Within the framework of this interface, an attempt was to be made to improve the deficiencies of IGES, SET and VDAFS which have the