The electrical circuit, Electrical Engineering

 

The electric circuit is drawn with the polarity of the voltages and currents shown by arrows

 

 

 

1435_electrical circuit.png

Posted Date: 8/20/2012 11:36:03 PM | Location : United States







Related Discussions:- The electrical circuit, Assignment Help, Ask Question on The electrical circuit, Get Answer, Expert's Help, The electrical circuit Discussions

Write discussion on The electrical circuit
Your posts are moderated
Related Questions
a. Determine how color sync burst and H deflection sync vary in amplitude and frequency. Also explain the difference in timing among the 3.58 MHz color sync burst and 3.58 MHz chro

Q. A simple parallel resonant circuit with L = 50 µH is used to performthe frequency selection. The circuit is to be tuned to the first station at a frequency of 1000 kHz. In order

Discuss important properties and uses of Ceramics. Ceramics - These are materials made by high temperature firing treatment of natural clay and specific inorganic matters. The

3-phase 180 0 mode VSI In 1800 mode VSI  each thyristor  conduct  for 1800 and two  thyristor  are fired  at 600 interval. For  example  if thyristor  T1  is fired at 00 then

Assuming that the receiver sends a XOFF signal when the receive buffer is P% full in order to avoid any data or packet loss.

What is Microprocessor? Give the power supply & clock frequency of 8085. A microprocessor is a multipurpose, programmable logic device that reads binary instructions from a sto

Question: (a) Consider the following RC admittance function: (i) If the function is to be realised using the Cauer II Form, find the values of the different components

To convert a galvanometer to a voltmeter, you should add a: a) High resistance in series b) High resistance in parallel c) Low resistance in series d) Low resis

Q. What is the voltage gain of common gate amplifier? The controlled source gmVgs is connected from drain to source with rd in parallel.The resistor is connected Rs is connecte

Saturation or active mode While V GS   > V th  and  V DS   > (V GS   - V th ) The switch is turned on, and a channel has been made that allows current to flow