The b-h curve for ferromagnetic materials, Electrical Engineering

Ferromagnetic materials have some 'residual magnetism' even when the current (proportional to H) is zero. Material with strong residual magnetism are useful for making permanent magnets 

1776_B-H curve.png

Posted Date: 8/27/2012 6:10:45 AM | Location : United States







Related Discussions:- The b-h curve for ferromagnetic materials, Assignment Help, Ask Question on The b-h curve for ferromagnetic materials, Get Answer, Expert's Help, The b-h curve for ferromagnetic materials Discussions

Write discussion on The b-h curve for ferromagnetic materials
Your posts are moderated
Related Questions
Q. Let a square-wave voltage source having an amplitude of 5V, a frequency of 1 kHz, a pulse width of 0.5 ms, and an internal source resistance of 50  be applied to a resistive lo

Q. Explain Shunt-field control process? Shunt-field control, armature-resistance control offers a constant-torque drive because both flux and, to a first approximation, allowab

Control  Bus The control  bus comprises of various  single  lines that carry  various  control  signals for synchronizing  various devices  and performing different task. The m

What are the modes used in display modes? 1. Left Entry mode In the left entry mode, the data is going into from the left side of the display unit. 2. Right Entry Mode

The resistance of a wire is 60 ? at 25 o C and 65? at 75 o C. Find the resistance of wire at 0 o C and value of temperature co-efficient at 0 o C. Ans: Given R 25 = 60 ? a

Q. An n-channel JFET with A = 300 V, P = 2 V, and I DSS = 10 mA is to be operated in the active mode. Determine i D when v DS = 10 V and v GS =-0.5V.

Composition of MOSFET  In a test pattern the Photomicrograph of two metal-gate MOSFETs. Probe pads for two gates and three source or drain nodes are entitled.Generally the se

Low Voltage at Transformers While the voltage applied to induction motor varies from the rated voltage, its performance is affected. Against permissible voltage variation of

Q. Design the low-pass filter shown in Figure (by determining L) to have a half-power frequency of 10 kHz.

Illustrate Common Emitter configuration, current amplification factor and collector amplifier. Describe transistor as an amplifier.