Tardy billing and poor revenue collection, Electrical Engineering

Tardy Billing and Poor Revenue Collection

Prolonged disputes, connivance, lack of consumer friendly policies, incorrect identification of category, fictitious billing (of non-existent consumers), lack of reconciliation and continuous provisional billing are causes for poor revenue collections. Delay in collections might be caused through late receipt of bill, customer inconvenience, wrong billing, non-receipt of bill and etc.

Posted Date: 2/6/2013 5:06:57 AM | Location : United States







Related Discussions:- Tardy billing and poor revenue collection, Assignment Help, Ask Question on Tardy billing and poor revenue collection, Get Answer, Expert's Help, Tardy billing and poor revenue collection Discussions

Write discussion on Tardy billing and poor revenue collection
Your posts are moderated
Related Questions
Q. Describe the operation of 8279. And also explain following terms: (i) N key Roll over. (ii) Key board debounce. (iii) FIFO RAM. Ans: 8279 is a programmabl

Q. Schematic Diagram of LED based System ? As shown in the two schematic diagrams above, the LEDs in a seven-segment display are not isolated from each other. Rather, eith

Define the term Causality LTI System Any practical LTI system operating in real time must be "causal" which means that its impulse response {h[n]} must satisfy h[n] = 0 for n

Q. Explain Modulation and sampling? Modulation is the process whereby the amplitude (or another characteristic) of a wave is varied as a function of the instantaneous value of


1. Find the Nyquist rate for the following signals: (a) x(t) = 5 sin 3000Πt cos 4000Πt (b) A binary channel with bit rate 36000 bps is available for PCM voice transmission.

Q. Explain the high-frequency response of FET amplifier?  The analysis for the high frequency response of the FET amplifier is almost the same as that of the BJT amplifier. The

how is it possible to operate Q3 with no dc drain? where is the dc operating point?

Describe the physical properties and uses of the Brasses. Brass - It is an alloy of copper and zinc along with 60 percent copper and 40 percent zinc. Its properties are- 1.

Turn-on, turn-off, and storage delay: The Bipolar transistor shows a few delay characteristics while turning on and off. Most of the transistors, and particularly power transi