## swot Analysis, Mechanical Engineering

Assignment Help:
what are the threats of mechanical engineering ?

#### Pre heat interpass temp. requirements for filler metals, PRE HEAT INTERPASS...

PRE HEAT INTERPASS TEMP. REQUIREMENTS FOR FILLER METALS The preheat and inter pass temperature must be sufficient to prevent the  cracking.Previous  Experience has shown that t

#### Truss, Truss: What are truss? When can the trusses be rigid trusses? ...

Truss: What are truss? When can the trusses be rigid trusses? State the condition which is followed by simple truss? Sol.: A structure made up of several bars riveted o

#### Thermodynamics, show that work is a path function and not a point funtion ?...

show that work is a path function and not a point funtion ?

#### Define the binary vapour cycle, Write brief notes on the following : (a)...

Write brief notes on the following : (a) Draught System (b) Binary Vapour Cycle (c) Cooling Towers (d) Governing of steam turbines

#### Hot pressing-manufacturing methods of ceramics, Hot Pressing This pres...

Hot Pressing This pressing requires application of pressure throughout sintering. In usual understanding hot pressing comprises in applying a unidirectional pressure via the a

#### Theoretical results-conventional priority rules, Theoretical Results I...

Theoretical Results In the particular machine case, several theoretical results are identified or can be derived: (a) If each operation can be scheduled such that everyone

#### Find out the forces in the members of the tower, Find out the forces in the...

Find out the forces in the members of the tower: Find out the forces in the members of the tower. Solution By symmetry, ∠ AFG = ∠ AGF = θ and HG = 7.5 m; while AH = 3

#### Moment of intertia, define moment of inertia

define moment of inertia

#### Stresses and strains, The round tensile specimen given  below has a diamete...

The round tensile specimen given  below has a diameter of 0.5 in. A load, F, is applied and the deflection, g , is calculated. Given the following                    d = 0.5 in

#### Compute the deflection and maximum bending stress, For the beam shown in Fi...

For the beam shown in Figure compute the deflection at the element nodes. The modulus of elasticity is psi and the cross section is as shown in the figure. Also compute the maximum  