Surge current - thyristor, Electrical Engineering

Surge Current

It is  the maximum admissible peak value of  a sinusoidal half  cycle of 10 ms duration at a frequency of 50Hz. The  value is specified at a given junction temperature .during   maximum  surge on state current  the junction  temperatures exceeded through  temporarily and forward blocking capability are lost  for a short period. The maximum surge on state  current should  only  occur  occasionally.

 

Posted Date: 4/2/2013 8:08:50 AM | Location : United States







Related Discussions:- Surge current - thyristor, Assignment Help, Ask Question on Surge current - thyristor, Get Answer, Expert's Help, Surge current - thyristor Discussions

Write discussion on Surge current - thyristor
Your posts are moderated
Related Questions
One of the simplest circuits is the asynchronous or ' ripple' counter. Below is shown the circuit diagram of a simple 3 stage ripple counter. The operation of this circuit

Q. Commercial FM radio broadcasting? Commercial FM radio broadcasting utilizes the frequency band of 88 to 108 MHz for the transmission ofmusic and voice signals. The carrier

Successive approximation ADC One method of addressing digital ramp ADC's shortcomings is so-called successive approximation ADC. Only change in this design is a very special c

Literature Review - Software Defined Radio In this section, first two methods to estimate signal to noise ratio (SNR) are reviewed and a few methods for modulation classificati

How can I design alternator?

Athree-phase, 440-V, 60-Hz, four-pole induction motor operates at a slip of 0.025 at full load, with its rotor circuit short-circuited. This motor is to be operated on a 50-Hz supp

which principle is used in d.c motor

What is mgnomotive force

Q. With the help of a npn transistor circuit and wave forms explain the working of an astable multivibrator In astable multivibrator both transistors are coupled to each other

Q. A coaxial cable with polyethylene dielectric (ε r =2.26) connects an antenna to a receiver 30maway. Determine the velocity of wave propagation in the cable and the delay of the