## stress strain, Mechanical Engineering

Assignment Help:

1. Determine young''s modulus using first 20 data points

2. Determine yield strain and yield stress based on -0.1 offset

3. Determine max(or min) stress.

4. Determine toughness

Display all above properly

On single graphm draw followings

5. Draw graph of original data with blue *

6. Draw initial regression using first 20 data points with red

7. Draw -0.1 offsetted regression line with green

Have another graph.

8. Draw 10 original data points around intersection with blue *. (for example, if intersection happens between data 60 and 61, plot original data from 56-65)

9. Draw line between two original data points before and after interseation with red line (for example, datat points between 60-61). Only between two data points

10. Draw offsetted regression line using 10 data points above with green line (for example, 56-65)

#### Tropical geometric information of solids, Tropical geometric information of...

Tropical geometric information of solids A face is surrounded by a set of vertices. Using the right-handed rule, the ordering of these vertices for describing a particular face

#### Copper-nickel alloys, Copper-Nickel Alloys Complete solubility arises ...

Copper-Nickel Alloys Complete solubility arises between nickel and copper. All alloys have same microstructure and may be cold or hot worked. Cupro-nickel also termed as Ge

#### What is the chief advantage of CIDR over addressing scheme, What is the chi...

What is the chief advantage of CIDR over the original classful addressing scheme? CIDR stands for Classless Inter-Domain Routing is a new addressing scheme for the Internet, th

#### Thermodynamics, Two kg Ammonia (mA) at PA = 300 kPa and TA = -10ºC and 1 kg...

Two kg Ammonia (mA) at PA = 300 kPa and TA = -10ºC and 1 kg Ammonia (mB) at PB = 300 kPa and TB = 100ºC are mixed in a constant pressure and adiabatic process. Find the following:

#### Switch assembly, Switch Assembly: A switch assembly consists of four ...

Switch Assembly: A switch assembly consists of four rails. The two outer rails are known as the stock rails. The two inner rails are called tongue rails. One stock rail and o

plate jig

#### Preliminary layout considerations, Q. Preliminary layout considerations? ...

Q. Preliminary layout considerations? This section outlines the key aspects to be considered when preparing preliminary layouts during the evaluate phase. Preliminary layouts a

#### Angular speed of the cylinder, Angular speed of the cylinder: A cylind...

Angular speed of the cylinder: A cylinder of mass 70 kg rotates from rest in frictionless bearing under the action of a mass of 7.0 kg carried by a rope wrapped around the cyl

#### Injection molding, finishing operation of telephone outer body after inject...

finishing operation of telephone outer body after injection molding

#### Design of screw feeder and screw conveyor, A new process plant for ore proc...

A new process plant for ore processing is currently being planned. The design is only in the first stage. However, three requirements have already been clearly stated: - The bins s