Storm water drainage - Road drainage and maintenance, Civil Engineering

Storm Water Drainage:

In city streets, the disposal of rain water has to be done through a system of underground storm water drains. The water is collected at the roadside kerb and is led into a covered storm water drain. Figure shows a typical arrangement.

Notes: (a) Collection of Water at A Bell Mouth Pipe 250 mm φ.

(b)   Covered Storm water drain at location B may be hume pipe/cast in situ/precast channel.

741_Sub-surface Drainage.png

Figure: Typical Cross-section of Urban Road Showing Storm Water Drains

Posted Date: 1/22/2013 5:20:41 AM | Location : United States







Related Discussions:- Storm water drainage - Road drainage and maintenance, Assignment Help, Ask Question on Storm water drainage - Road drainage and maintenance, Get Answer, Expert's Help, Storm water drainage - Road drainage and maintenance Discussions

Write discussion on Storm water drainage - Road drainage and maintenance
Your posts are moderated
Related Questions

how activity charts and string diagram use in work study?

Q. How can you design Side Slope of bank? Angle of bank should be flatter than angle of repose of pitching material. Angle of repose of sand is 2:1 while that of stone is about

Define Black & White Fathometer - Non-Destructive Testing? Most commonly used sounding device is black & white fathometer. The units are compact and easy to use. They consist o

Explain the term - Moderate Prestressing In this form of prestressing, no limit is imposed on  the magnitude of tensile stresses which may be produced in a concrete member unde

which kind of pile can increase the bearing capacity, if the water level high in sang soil surface?

Define Construction damage - underwater inspection of bridge? Construction damage can result from improper procedures during the construction phase.  Some examples are: -  P

As the term implies, "Modulus of Elasticity" shows to the elasticity or "flexibility" of a material. The value of modulus of elasticity is very much important relating to deflectio

how to draw load intensity and bending moment diagram form a given shear force diagram

An electrical contractor is preparing to place the duct bank concrete encasement for the high voltage feeders between manhole # 11 and # 12, total distance is 323-ft. The duct bank