Steps of engine oil replacement and top-up, Mechanical Engineering

Assignment Help:

Engine Oil Replacement and top up steps

• The engine oil should be changed only when motorcycle has run through the prescribed kilometers.

• Change the engine oil every 4000 kms if it is 4 T Plus oil.

• Change the engine oil every 2000 kms if it is not a 4T Plus oil.

• If the engine oil change is not due then also an inspection is made by the dipstick.

• The area near the dipstick is cleaned with a cloth.

• Remove the dipstick and wipe it clean.

• Put the dipstick in the engine again.

• Take care that when the dipstick is put in the engine to inspect oil level, it should not be tightened (screwed).

• Remove the dipstick for inspection. The engine oil should be visible between the upper and lower level marks.

• If required the engine oil should be topped up with recommended clean engine oil.

• If the engine oil is to be replaced it should be changed as per the recommendation.

• To change the engine oil, keep an oil tray below the engine.

• Remove the drain bolt and sealing washer.

• Let the oil drain into the oil tray. It would take some time to drain the whole oil from inside the engine.

• Tilt the vehicle in both sides to ensure the total draining.


Related Discussions:- Steps of engine oil replacement and top-up

Impulse turbine, IMPULS E TURBINE: The steam turbine in which the ste...

IMPULS E TURBINE: The steam turbine in which the steam expands while passing through nozzle and remains at the constant pressure over the blades is called as impulse turbine.

Determine the machine working, Determine the theoretical COP for a CO 2 ma...

Determine the theoretical COP for a CO 2 machine working between the temperature range of 25 O C and -5 O C. the dryness fraction of CO 2 gas during the suction stroke is 0.6. fo

Vendor drawing and data review, The Mechanical Engineer/Specialist shall be...

The Mechanical Engineer/Specialist shall be responsible for specifying Vendor Drawings and Data Requirements in the MRQ and MRP using the WorleyParsons standard vendor drawing and

Applications, applications of dynamically induced emf

applications of dynamically induced emf

Can you explain the mobile bed model, Q. Can you explain the Mobile bed mod...

Q. Can you explain the Mobile bed model? Mobile bed models can again be either geometrically similar or vertically exaggerated. Models of the former type permit study of proble

Design and sketch a knuckle joint to transmit a tensile load, Give a genera...

Give a generalized definition of factor of safety. Illustrate the factors responsible for Un-certainities in design necessitating a suitable factor of safety. How is ‘factor of saf

Explain the advantages of rack cutter, Explain the Advantages of Rack Cutte...

Explain the Advantages of Rack Cutter? a. A single cutter of any specific pitch can cut gears of any number of teeth having similar pitch. b. The tooth profile produced is m

Calculate pressure on each side of spherical ball , Calculate pressure on e...

Calculate pressure on each side of spherical ball : Heavy spherical ball of weight W rests in V shaped trough whose sides are inclined at the angles and to the horizontal

Potential energy and kinetic energy- thermodynamics, Potential energy (PE) ...

Potential energy (PE) The energy possessed by body or system by virtue of its position above the datum level. The work done is because of its falling on earth's surface. Po

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd