Steps for solving problem for finding power, Mechanical Engineering

STEPS FOR SOLVING PROBLEM FOR FINDING POWER:

1. Use formula stress (s) = force (Maximum Tension)/Area

Where; Area = b.t that is, Tmax = σ.b.t

2. Unit mass (m) = r.b.t.L Where;

r = Density of material

b = Width of Belt t = Belt thickness L = Unit length

Take L = 1m, if b and t are in meter

Take L = 100cm, if b and t are in cm

Take L = 1000mm, if b and t are in mm

3. Calculate V using V = ΠDN/60 m/sec

4. TC  = mV2, For finding TC

5. Tmax  = T1 + Tc, for finding T1

6. For T2, By using relation Ratio of belt tension = T1/T2  = eµθ

7. Power Transmitted = (T1-T2).V/1000 Kw

Posted Date: 10/19/2012 6:56:43 AM | Location : United States







Related Discussions:- Steps for solving problem for finding power, Assignment Help, Ask Question on Steps for solving problem for finding power, Get Answer, Expert's Help, Steps for solving problem for finding power Discussions

Write discussion on Steps for solving problem for finding power
Your posts are moderated
Related Questions
(a) What will happen if air filter is not used? (b) What are the components of an air filter? (c) What precautions should be followed while cleaning the air filter? (d) What grade

ARC CHARACTERISTICS In order to understand the different output characteristics that are required by the welding power source it is necessary to understand the load which is f

Concept of continuum - thermodynamics: Sol: Even the simplification of matter into molecules, atoms, electrons, etc. is too complex a picture for many problems of thermodyna

Airlines like to overbook their flights (this is a vibrant area of research called yield management). It is estimated that 10% of the people who book their flight do not show up. H

Cylinder Bore: The nominal inner diameter of the working cylinder is called the cylinder bore and is designated by the letter D and is usually expressed in millimetre (mm).

Objectives After studying this section, you should be capable to: known properties that are essential to be present in a material for high temperature applications,

Mounting Systems For The  Welding Head Submerged arc welding head may be mounted by one of the following three methods. a. Fixed type b. Carriage mounted type c. Boom mounted ty

The three prototyping methods used are: a)  R a p i dPrototyping: This is used to model the pins (large 1, 2 and small), lock disk and crank. b)   CNCMachining: Use

Applications of spot welding As spot welding can be employed for Al, Cu, Ni and Mg alloys. It is not advisable to spot weld steels with carbon content greater than 0.25 % unles

Four Stroke Engine - thermodynamics: Figure given below shows the working of a four stroke engine. During suction stroke only air (in case of diesel engine) or air with petrol