Spot welding of different metals-aluminium and its alloys, Mechanical Engineering

Spot welding of different metals-Aluminium and its alloys

High currents and shorter welding times are necessary for these materials. Special cleaning of the surface is warranted in order to remove the oxide film if high quality welds are required. The material is first decreased with trichloroethylene. Pickled by dipping in a suitable etching solution, washed and dried. Here, the upper limit is 6 mm thickness plate.

Posted Date: 9/17/2012 3:16:05 AM | Location : United States







Related Discussions:- Spot welding of different metals-aluminium and its alloys, Assignment Help, Ask Question on Spot welding of different metals-aluminium and its alloys, Get Answer, Expert's Help, Spot welding of different metals-aluminium and its alloys Discussions

Write discussion on Spot welding of different metals-aluminium and its alloys
Your posts are moderated
Related Questions
Given these sinusoids: x1(t) = 0.5cos(25t+20 o ),   x2(t)=0.85cos(25t+160 o ) and   x3(t)= 0.81cos(25t-145 o ) (a) Subplot the phasors X1, X2 and X3 corresponding to the thee si

Give differences between direct stress and bending stress. Direct tensile and compressive stress is set up because of load applied parallel to length of object, and direct shea

State the Product Data Exchange Specifications In May 1984, a late night meeting of the IGES Organization Edit Committee was held. The outcome: the Boeing representative was

A beam, 6 m long is simply supported at the ends, and carries a uniformly distributed load of 15 KN/m and three loads of 10 KN, 20 KN and 30 KN acting respectively at the centre po

the pump, shown in the figure, is used to deliver water to a distribution system. there is no flow to or from reservoir A, but it is used to damp pressure and protect the pump. th

Lubrication Complaints If the engine oil level is too low, check for the following things: External oil leaks Worn out piston rings Worn out valve guide and/o

Before installing a bolt, stud or nut, threads shall be examined to ensure that there are no incompletely cut threads in the engagement zone (both internal and external) or burns,

Determine the angular-velocity of uniform bar: A uniform bar of length l and mass M is hinged at its end B and is released from its horizontal position BA. Determine its angul

Classification Based on Type of Welding  Fusion welding : These processes involve fusion of the base metal to complete the weld. Fusion welds generally  do  not  require  thea

what force will be neccesary to just maintain a body at equilibrium in a body weighing 914.5kg along the horizontal plane