Specifications - boilers, Mechanical Engineering


 The boilers are specified as per following parameters :

-     Steam Generation Rate : for instance 50 000 kg /hr.

-     Maximum Pressure: for instance 150 kg/ sq.cm

-     Dimensions of steam drum

-     Horizontal / Vertical

-     Water / Fire Tube

-     Natural / Forced   Circulation

-     Type of Fuel Used: Coal / Oil / Gas etc.



Posted Date: 10/20/2012 2:35:26 AM | Location : United States

Related Discussions:- Specifications - boilers, Assignment Help, Ask Question on Specifications - boilers, Get Answer, Expert's Help, Specifications - boilers Discussions

Write discussion on Specifications - boilers
Your posts are moderated
Related Questions
Derive the mathematical expression for temperature distribution for plane wall with internal heat generation when both the surfaces are at same temperature?

Information phase of screw conveyor with auger: Steps: To secure all and complete information and gather facts and from best sources.Our project is selected based on the cu

INTREPRETATION OF DEFECTS Intrepretation is an important factor is controlling the quality of the product on economic levels. Sometimes for want of proper decision, proj

Nitrides, Silicides and Sulfides Nitrides contain very high melting point but initiate to oxidize at low temperature. They have poor resistance also to chemicals. Boron nitrid

Calculate plastic zone: Calculate plastic zone ahead of crack in above problem if σY = 250 MPa. Solution From Eq. Here KI is taken as KI max since the plastic

Resistance Seam Welding This is similar to spot welding except that the copper alloy electrodes are in the form of circular rollers. The overlapping sheets are held under const

Conve r t following reading of pressure to kPa, supposing that the barometer reads 760mm Hg. (1) 90cm Hg gauge (2) 40cm Hg vacuum (3) 1.2m H 2 O gauge Sol: Given

Concept of process - Thermodynamics: A process can be defined as change in the state or condition of a substance or working medium. For instance, heating or cooling of thermod

Explain the point of contraflexure?

You are required to formulate the loading and boundary conditions using the FE code and evaluate the stress distribution and end deflection of the beam using the ABAQUS code and vi