Smoke control system, Other Engineering

Smoke control system:

Where smoke control is installed in a building it is usual for there to also be sprinkler protection to the building and its contents.  This is necessary because smoke control systems cannot usually cope with the smoke from very large fires and the quantity of smoke has to be restricted.

Sprinkler systems that are designed to protect life as well as property have features that make them more reliable such as by-passes at the main valve to allow the system to remain active whilst the main valve is being worked on and warning systems for alerting staff to any part of the system that might be turned off.

 

Posted Date: 10/22/2012 6:44:28 AM | Location : United States







Related Discussions:- Smoke control system, Assignment Help, Ask Question on Smoke control system, Get Answer, Expert's Help, Smoke control system Discussions

Write discussion on Smoke control system
Your posts are moderated
Related Questions
Alternative escape routes: Does everyone have access to the alternative routes or do some people have no choice about which way they go? Are all the escape routes

Fuel system inhibiting. The fuel used in turbine engines usually contains a small quantity of water which, if left in the system, could cause corrosion. All the fuel should th

construction and working of counter flow tray

The tensile strength of the core material in a sandwich structure can be determined using the flat-wise tension fixture shown below. The sandwich is bonded between two al

different operating modes of npn transistor

The following exchange rates are available to you. (You can buy or sell at the stated rates.) Mt. Fuji Bank ¥85.00/$ Mt. Rushmore Bank SF1.356/$ Mt. Blanc Bank ¥64.74/SF Assume t

Bearing stresses are very common in aerospace engineering.  It occurs on the surface of contact between any two structural members.  Bolts, pins, and rivets are classic examples of

Exhaust Jet Mixing: Figure shows that the noise from the exhaust jet is the main contributor to the total noise generated by a low by-pass ratio turbo-fan. For a turbo-jet the

Thin-skinned Structures  The SCB geometry can't be used because the skins are too flexible.  Instead, a centre-notch flexure (CNF) test can be used. A hole is drilled abo

Why would an investor buy preferred stock? A buyer that wants the benefit potential of value but wants to reduce possibility would buy recommended inventory. The buyer would rec