Skeleton pattern, Other Engineering

A half skeleton pattern for a hollow pipe is shown. Since the pipe is symmetrical about the pouring line, the same pattern will serve the purpose of moulding both the halves in two different flask which can be joined later to form the complete vacity.

Posted Date: 8/3/2012 2:09:11 AM | Location : United States







Related Discussions:- Skeleton pattern, Assignment Help, Ask Question on Skeleton pattern, Get Answer, Expert's Help, Skeleton pattern Discussions

Write discussion on Skeleton pattern
Your posts are moderated
Related Questions

PEME5451/3451 SUSTAINABLE ENERGY PROCESSES Assignment 5: Transport fuels VLE submission deadline is Friday 24th February PART 1: (worth 40%, all parts marked equally) 1. Using the


Using this link and the information therein ( http://www.sec.gov/Archives/edgar/data/1110452/000119312507151600/d20f.htm#tx19738_13.) find Air France’s weighted average cost of ca

The unity gain follower: The somewhat lengthy term operational amplifier will now be dropped and it will be referred to, as most people do, simply as the op amp.  The simplest

A speed control system has an amplifier-motor-control element capable of maintaining a speed of 4000 rpm at the output shaft with no external load and an input of 8 mV to the ampli

occasionally we are getting black streaks in our powder coated parts. Does not seem to be related to paint contamination or cleaning prep. Has anyone else seen this or know what co


Hot Section Inspections (HSI's) The hot section includes all components in the combustion and turbine sections of the engine. Scheduled inspections may involve visual inspectio

Inlet duct arrangement in Aircraft Engine: Wherever the APU is located, ducting will be required to bring air to the APU inlet. In figure 18.9. we can see that the inlet duct