Simulink software, Civil Engineering

Using Matlab/ Simulink software to model the overall building fabric heat transmit characteristics, in order to estimate the maximum rate of heat loss (kW) from the building under design internal operating temperature and an average heating season outside temperature. 

Posted Date: 3/26/2013 7:04:50 AM | Location : United States







Related Discussions:- Simulink software, Assignment Help, Ask Question on Simulink software, Get Answer, Expert's Help, Simulink software Discussions

Write discussion on Simulink software
Your posts are moderated
Related Questions
shrinkage factor in plans

Q. Case of Multi speed restrictions? Position of Engineering indicators in case of Multi speed restrictions on one of the line in a Double line section where the first speed re

To determine the specific gravity of fine aggregate (sand) by Pycnometer.

Explain the Strength Design (LRFD)   1. γ Factors are applied to loads and φ factors applied to resistance. 2. Unfactored service loads receive a load factor γ > 1.0

What is the calculation method of load bearing capacity of formwork material?

Question What is major difference between "hammer efficiency" and "coefficient of restitution" at what time using Haley's formula in pile driving?   Answer Hammer ef


Define Equipments required for conducting UWMT? Equipments required for conducting UWMT are: Inspection Equipment: a) Electronic yoke with power cable b) Ground fault interr

Explain the Damage inspections - underwater inspection of bridge? Sometimes referred to as post-event inspections, damage inspections are typically unscheduled inspections aime

A 1.8 m square column is founded at a depth of 1.8 m in sand, for which the accurate N-value is 24. The water table is at a detph of 2.7 m. Verify the net allowable bearing pres