Shell-mould casting, Other Engineering

Shell-mould Casting is variant of the resin bonded sand technique for casting steel, iron or non-ferrous alloys.

The mould is made by a mixture of fine sand (100 - 150 mesh) and a thermosetting resin binder that is placed against a heated metal pattern, preferably made of grey cast iron.

Posted Date: 8/3/2012 1:23:34 AM | Location : United States







Related Discussions:- Shell-mould casting, Assignment Help, Ask Question on Shell-mould casting, Get Answer, Expert's Help, Shell-mould casting Discussions

Write discussion on Shell-mould casting
Your posts are moderated
Related Questions
I have a multi-part three mass, three spring and three coordinate system that I need to find: The free vibration of the second mode Magnitude of the steady-state force based on a g

TRANSPORT 2 CHEMICAL PROCESS CONTROL CHEMICAL REACTIONS ENGINEERING

Fractional distillation This process is carried out in a fractionating column, which has a series of trays as shown in the figure. The effect of the superheated steam on the h

A basic instrumentation system consists of a transducer, conditioning amplifier, and analog digital converter connected (in general) by analog and digital transmission lines.

The axial flow compressor: The axial flow compressor is by far the most popular type of compressor and, although it is more difficult to manufacture, it is a more efficient com

Introduction Engineering Economic Analysis Definition: using a combination of quantitative and qualitative techniques to analyze economic differences among engineering design a

Logic Gates: The term logic in electronics refers to the representation and logical manipulation of numbers usually in a code employing two symbols. i.e., bits. An electron


IGNITION SYSTEMS The outline of a high energy ignition system is illustrated in the figure. Each high energy ignition unit has a low voltage supply which is controlled by the

I want to plot x1=4exp(t/4) x2=sin(2Pift+pi/2) and x3=x1x2 in CcS