Service paradigm, Computer Networking

At the minimum level most networks sends individual packets of data and the network needs each packet to follow an exact format dictated by the hardware, which is known service paradigms or Interface paradigms.

There are two kinds of service paradigms:

CONNECTION-ORIENTED:

It is same as the telephone system: endpoints create and maintain a connection as long as they have data to interchange.

CONNECTIONLESS:

Same as postal system: endpoints put data to transmit into a packet and deliver to network for delivery.

Posted Date: 7/31/2012 7:59:58 AM | Location : United States







Related Discussions:- Service paradigm, Assignment Help, Ask Question on Service paradigm, Get Answer, Expert's Help, Service paradigm Discussions

Write discussion on Service paradigm
Your posts are moderated
Related Questions
Recognize the two commands that copies the configuration in NVRAM to RAM Ans) a) Copy startup-config running-config b)  Configure memory

What is Multiplexing? Multiplexing is the set of techniques that permits the simultaneous transmission of multiple signals across a single data link.

What is CRC and Checksum CRC (Cyclic redudancy check) CRC, is the most powerful of the redundancy checking methods, is based on binary division. Checksum Checksum

Connections in ATM are known virtual circuits or virtual channels These are known virtual, since connections are created in ATM by starting values in memory locations (tables) in A

Cisco Router architecture Overall architecture of Cisco 2600 router is given below The Following components of routers are 1.    WIC slots 2.    communications

Ethernet Frame Fields Preamble - seven bytes of alternating 0s also 1s to notify receiver of incoming frame and to provide synchronization SFD (Start frame delimiter)

Next hop to receiver does not relay on source of packet. This phenomenon is known 'Source Independence'. It has various benefits. It gives efficient and fast routing. Packet switch

#questionWrite a program to find the area under the curve y = f(x) between x = a and x = b, integrate y = f(x) between the limits of a and b. The area under a curve between two poi

What are the Access methods used in LAN: i. Switched access: It is used in LANs which are assigned around CBXs. Electronic switching is techniques are used to provide access

Encoding Process c= uG u: binary data sequence of length 4( input) G: Generator matrix which is 7*4 c: Codeword     D