Series spot welding, Mechanical Engineering

Series Spot Welding

In series welding, a portion of the secondary current by passes any weld nugget being formed. And This shunt current passes through one of the panels being welded. Generally, two welds are made per transformer secondary.

 

Posted Date: 9/13/2012 6:15:00 AM | Location : United States







Related Discussions:- Series spot welding, Assignment Help, Ask Question on Series spot welding, Get Answer, Expert's Help, Series spot welding Discussions

Write discussion on Series spot welding
Your posts are moderated
Related Questions
prove that the sensitiveness of a proell governor is greater than that of a porter governor

Hydraulic calculations are carried out by both Process and Mechanical Engineering. Generally speaking, Process Engineering will initiate many hydraulic calculations for piping sys

(a) Why does engine overheat and what will happen if engine overheats? (b) Why engine does not start in wet or damp weather? (c) What may be the causes if engine dose not sta

In this assignment you will apply what you have learned in previous training. Consider the part in figure, which constructed from a solid tube. The bracket is supported at surface


Work related area of CAD Work related to the following areas has been addressed in this interface.  Investigation of CAD data structures and the presentation of 2-D and

Design a concrete pedestal for a steel column carrying a dead load of 600 kN and an imposed load of 600 kN. Assume the base plate is 350 mm x 350 mm M20 grade concrete and F e , 41

Mounting Systems For The  Welding Head-Carriage mounted type In this set up, the welding head is mounted on a movable carriage. The carriage is mounted on rails and powered by a

what is interference and undercutting?

a) Consider a brake of your choice and Illustrate self locking and self energizing condition & its significance in brakes design. b) Discuss thermal condition in brake design.