Seat belt warning system, engineering, Other Engineering

Expertsmind.com brings you unique solution in Electrical Engineering

 

Seat belt warning system

Seat belt warning system is developed to cut off the car’s ignition circuit to avoid the engine from start or operation while the operators are not tiring their seat belt both the ignition and starter circuit can be isolated. Common operation starts again as the operator fasters.

Seat Belt Warning Light System

Design circuit for warning light

Sensors

        If “I” is high: ignition is on

        If SB is high: seat belt fastened

        If SS is high: seatbelt sensor is on

Expression of  Boolean algebra equation

Ignition is on, and seat belt not fastened, and

           Seatbelt sensor is on 

W = I AND not SB AND SS

change equation to circuit                    

1336_Seat-Belt-System.png

Take in action - Boolean algebra allows simple capture as equation and conversion to circuit.

Posted Date: 2/11/2012 11:58:25 PM | Location : United States







Related Discussions:- Seat belt warning system, engineering, Assignment Help, Ask Question on Seat belt warning system, engineering, Get Answer, Expert's Help, Seat belt warning system, engineering Discussions

Write discussion on Seat belt warning system, engineering
Your posts are moderated
Related Questions
Where do you think by DJIA? Nobody knows the respond to this one. However, you should at least have some ideas on the topic and be able to communicate why you think this is the

Calculatethe tax disadvantage to organizing a U.S. business today, after passage of the Jobs and growth Tax relief reconciliation act of 2003, as a corporation versus a partnership

Feathering the propeller: If there is an engine failure in flight, the propeller would windmill creating drag and increasing any damage that had occurred in the engine. Feathe

When a beam of monochromatic x ray is incident on a graphite block, it get scattered and scattered wavelength is larger than that of the incident radiation wavelength. This scatter

Bay cooling in Aircraft: There are two methods of bay cooling, they are: • Ram air cooling • Fan air cooling RAM AIR COOLING For ram air cooling, the aircraft has to

THE INVERTER ('NOT' GATE) Figure shows the symbol for an inverter, where the output will produce the complement of the input. This device is often employed when the complement

Mode III Interlaminar Fracture Toughness  The Mode III interlaminar fracture toughness of a composite can be measured using the split cantilever beam (SCB) geometry. Here, a c

Difference amplifier: Figure shows how two inputs can be subtracted. This circuit differs from previous types with negative feedback in that the non-inverting terminal is not


Cathode ray tube (crt): Displays of this type, which are based on the electron beam scanning technique, have been used in aircraft for many years.  They were first used to disp