Sand blasting handling method, Mechanical Engineering

Sand blasting handling method:

            On last experiment we had decided to use 3.0 bars as it shown better result. Now we had to investigate the sand blasting handling method. Instead of trying sand blasting horizontally we decided to go on with blade rod stand firm vertically and the sand blast nozzle moving up and down vertically to perform sand blasting.

Experiment data:

No Blade Rod

Air Pressure

0.5 bars

1.5 bars

2.0 bars

3.0 bars

1

x

x

2

x

3

x

x

x

4

x

x

5

x

6

x

x

x

7

x

8

x

x

x

9

x

x

10

x

Table: Test result on vertical method

            The result of the experiment shown that vertical handling method had able to de-burrs all burrs on blade tips.

1956_Sand blasting handling method.png

Figure: Shown the method of horizontal handling and vertical handling method

Posted Date: 2/18/2013 2:12:18 AM | Location : United States







Related Discussions:- Sand blasting handling method, Assignment Help, Ask Question on Sand blasting handling method, Get Answer, Expert's Help, Sand blasting handling method Discussions

Write discussion on Sand blasting handling method
Your posts are moderated
Related Questions
Q. Basic requirements of a control scheme of steam generators? The basic requirements of a control scheme are: • Master steam pressure control by feedback to the water flow

Ductile mid brittle material: A material that can undergo large permanent deformation in tension, that is, it can be drawn into wires is called as ductile. A material which

A large tower is to be supported by a series of steel wires; it is estimated that the load on each wire will be 13,300 N (3000 lb f ). Determine the minimum required wire diameter,

Sales incentives , introduction of new models as well as variants coupled with easy availability of low cost finance with comfortable repayment options continues to drive demand an

Drum Brake: The construction of drum brake is clearly shown in Figure 2.40. In a rotating brake drum stationary brake shoes are attached concentric to the axle hub. A back plate

W orking Principle of the Petrol Engine: OTTO CYCLE     5-1 Suction Stroke 1-2 Adiabatic Compression Stroke 2-3 Heat Addition at the constant Volume.

WIRE MELTING CHARACTERISTICS A non linear relationship exists between the rate at which the wire is fed into the arc and the current required to burn it off to maintain a constan

Gibson Ltd operates sportswear stores in Dublin and Cork and has set the following quarterly sales target for international and provlncial rugby shirts for 2013 per the attached sc

Q. Explain Rate Pressure Product? The systolic blood pressure is multiplied by the heart rate to provide the double product or modified fusion time index. On presence of an obs

I want complete information about the topic torsion of cylinder and torsion rigidity.if I have to make a project on this topic then how should I make it. Please help me sir.