Road materials, Civil Engineering

Road Materials

Earthwork and pavements constitute a significant part of the cost of a road. Hence it is desirable that thorough investigations be done about the availability of soil and other road materials of good quality at economical distance.

Objectives

After studying this unit, you should be able to

  • know the procedures involved in identifying and testing of soil, and
  • understand the property of aggregates and binders like bitumen and cement for road work.

 

Posted Date: 1/22/2013 2:44:15 AM | Location : United States







Related Discussions:- Road materials, Assignment Help, Ask Question on Road materials, Get Answer, Expert's Help, Road materials Discussions

Write discussion on Road materials
Your posts are moderated
Related Questions
Design a 10 unit rapid sand filter system for a flow of 6.3 MGD with a filtration rate of 2 gpm/sq ft. and an L: W ratio of 1.3.   Design flow (Q) = 6.3 MGD = 6.3x106 gpd =

Obtain the values and direction of the supporting reactions of the truss given below. Use the method of section to determine the forces in each member.

Advantages of bonded post-tensioning systems Some advantages of bonded post-tensioning systems over unbonded post-tensioning ones are the following : (a) Large reduction in

Q. Optimum binder content in bituminous pavement? Amount of binder to be added to a bituminous mixture can't be too excessive or too little. Principle of designing the optimum

A retaining wall, 6 m high, retains dry sand with an angle of friction of 30° and unit weight of 16.2 kN/m 3 . Verify the earth pressure at rest. If the water table rises to the to

Q. Best efficiency point and operating point for pumps? In a pumping system, a system curve can be derived based on static head needed to lift up the fluid and variable head be

Design of the Aeration Basin Based on Solids Retention Time - sewer construction: You are provided the following information about a municipal wastewater treatment plant. That


uses of timber in civil engineering field and its physical state and chemical formula or symbol?

If you have water pressure and wish to handle it, do not cause flow in the line, which will decrease pressure because of friction. To keep pressure up, decrease friction by increas