refrigeration, Mechanical Engineering

winter&summer refrigeration .
Posted Date: 10/13/2012 4:08:54 AM | Location : United States







Related Discussions:- refrigeration, Assignment Help, Ask Question on refrigeration, Get Answer, Expert's Help, refrigeration Discussions

Write discussion on refrigeration
Your posts are moderated
Related Questions
Develop an EES Code for a Rankine cycle with reheat and with 2 open feedwater heaters.  The cycle is shown below:  Use the following conditions: 1.  700 psi, 850F 2.  500

Flash Butt Welding The two pieces to be welded are pressed against each other by applying a pressure. To whatever finish the faces are machined, there will be some protuberance

Solve the following two questions of the truss. Note that A and G are pin supports.  1)  Sketch the influence lines for the force in bar DG (the load is moving on the top chord

derive the torsion formula as (torsion divided by radius) is equal to (modulus of rigidity multiplied by twist of angle all divided by the length of a cylinder)

Details of rolling process,Different rolling methods,

what is tool cost?

For two waves period, determine the time response x(t) for the system (ignoring viscous damping effect only)  Give=n: X0=0.09615 , θ(radians)=0.110*π , μk=0.80000 , μs=0.90000 , K=

Classification of welding Based on Mode of Energy Transfer Energy is converted from one form to another. Any form of energy can be converted to heat energy, which can be used f

what are the necessery calculation required to design a gripper?

Q. What is Clad plate and overlay welding? Strip back cladding on clad plate a minimum of 5 mm (3/16") from the edges of weld preparation before welding on the backing plate.