Refractoriness under load (rul), Chemical Engineering

Refractoriness under load (RUL): This represents the resistance of a refractory material to the combined efforts of heat and load. RUL is the temperature at which the deformation begins and at which at least 10% deformation takes place. It is necessary that refractory material must also possess very high mechanical strength even at operating temperature to bear the maximum possible load without damage.

 

 

Posted Date: 7/21/2012 9:08:25 AM | Location : United States







Related Discussions:- Refractoriness under load (rul), Assignment Help, Ask Question on Refractoriness under load (rul), Get Answer, Expert's Help, Refractoriness under load (rul) Discussions

Write discussion on Refractoriness under load (rul)
Your posts are moderated
Related Questions
Find the single pass and overall conversion of CO Carbon monoxide and hydrogen react to form methanol. However nitrogen is often added as an inert. 100 moles that contains 4 mo

If 2 grammes of zinc granules was reacted with excesss hydrocloric acid to evolued hydrogen gas which came to completion after 5 minutes. Calculate the rate of the chemical in gram


A chemical specie decays over time when is subject to air and simultaneously reproduced by another process as given by:  where c is the concentration of the specie and co i

Mixing Salt Solutions You mix 195.0 gallons of a mixture containing 12.00 wt% NaCl (sodium chloride) and 88.00 wt% water (solution density = 1.0837 g/cm 3 ) with a V 2 -gallon

#explain the process of x-ray production..

Refractoriness: It indicates the capacity of a material to withstand heat without appreciable deformation or softening under particular operating conditions and is measured as the

1. What are chemical fuels? How they are classified?  List the characteristics of a good fuel. 2. Define cracking. Explain the fluidized catalytic cracking method with neat diag

I need help in developing a program in matlab that can simulate a reactive distillation column. I have all the required model equations needed for the simulation. pls contact me as

the pilling bedworth ratio of iron is 1.77 why it not stable as per rulr