RC helicopter, Mechanical Engineering

how to make ? what are the components needed ?
Posted Date: 3/2/2013 7:16:10 AM | Location : USA







Related Discussions:- RC helicopter, Assignment Help, Ask Question on RC helicopter, Get Answer, Expert's Help, RC helicopter Discussions

Write discussion on RC helicopter
Your posts are moderated
Related Questions
Washing: Station 1 Loading bay START Station 2 Hot Chemical wash Station 3 Running Cold bath Station 4 Hot C

a) Illustrate with neat and clean diagram the measurement of brake power by prony brake Dynamiter OR Belt transmission type Dynamiter. b) A torsion dynamometer is fixed to a pro

Human Factor : The human factor is the key factor in the success of CAD system. This concerns the training of the designer or the engineer without whom the CAD system become

Changes in Mechanical Properties along with Tempering: Tempering enhances the toughness and ductility of quenched steel though decreases hardness. Following figure demonstrate


Deferentiate between hot working and cold working processes

D i f fe r enc e between components and resolved parts: 1. When the force is resolved into two parts along the two mutually perpendicular directions, the parts along th

how to produce a design that meets the specification given: Beam Dimensions W, H and T, where H=2W and T=W/20 • Bolt Size D1 • Side Plate thickness T2 and width W2 • Cradle Plat

Evaluate the reactions at hinge and roller support: Q: A Force P = 5000N is applied at centre C of beam AB of length 5m as shown in figure given below. Find the reactio

Movement of wire at the signal box: The wire working on railway signal is 5mm in diameter and 300m long. If movement at the signal end is to be 25cm, make calculations for mo