rapid prototyping, Mechanical Engineering

Give justification toward the development of rapid prototyping?
Posted Date: 4/3/2013 9:53:45 AM | Location :







Related Discussions:- rapid prototyping, Assignment Help, Ask Question on rapid prototyping, Get Answer, Expert's Help, rapid prototyping Discussions

Write discussion on rapid prototyping
Your posts are moderated
Related Questions
Q. What are the Specific Issues with plant Layout? There are a large number of regulations and related material that impact the operating plant. API (American Petroleum Institu

What is Tube Drawing - cold drawing processes This kind of drawing is very similar to bar drawing process and in majority of cases it is accomplished by the use of a draw be

Find out diameter of steel wire: Q: A load of 5 KN is to be raised with help of steel wire. Find out diameter of steel wire, if maximum stress does not to exceed 100 MNm 2

Basic elements of flashbutt welding A flash butt welding machine is mainly comprised of a Main frame Stationary Platen Moving Platen Clamping mechanism Transf

Q. Identification of Pressure Welds? Pressure welds shall be identified as follows: a. Generally each weld shall be stamped adjacent to the weld with the welder's identity c

Inspection of Electrical Equipment STEPS All electrical equipment are checked for proper functioning. The starting and lighting of the motorcycle should be prope

Refractoriness The capability of a material to withstand the action of heat devoid of appreciable deformation of softening is submitted to as refractoriness. Such property is m

Expression for normal and shear stress: Derive expression for normal and shear stress on the plane AE inclined at an angle B with AB subjected to the direct stresses of compr

Cylinder Block: This serves as an enclosure to the cylinder. The cylinder is an integral part of cylinder block in 100 cc motorcycle. Figure : Cylinder Block

Evaluate an expression for minimum number of teeth on the wheel if interference is to be avoided between two mating gears. Also determine the above expression if gear ratio is equa