Radar systems, Other Engineering

Radar Systems
  • Radar is an acronym for RAdio Detection And Ranging. 
  • A radar uses an antenna to transmit a series of electromagnetic waves or pulses, and an antenna (usually the same one) to detect electromagnetic signals that have been reflected off objects of interest.
  • The time delay between transmission and receiving the reflected signal gives information about the range of the reflector, and the 
  • frequencies and polarisations present in the received signal gives more information about the position and the structure of the reflector. 
  • Radar system operate in a wide variety of wavebands from wavelengths of 10s of metres to wavelengths of the order of 1 mm.
  • The details of radar operation are not importan for this course, but some appreciation of radar accuracies and their limitations is useful.
Posted Date: 8/27/2012 9:22:44 AM | Location : United States







Related Discussions:- Radar systems, Assignment Help, Ask Question on Radar systems, Get Answer, Expert's Help, Radar systems Discussions

Write discussion on Radar systems
Your posts are moderated
Related Questions
Pls solve the problem 13-7 in Statistical Quality control by Montgomery


Blow Holes                    (i) Excessive moisture in the moulding sand.                   (ii) Low permeability and excessive fine grain sands.                   (iii

AS A CONSULTANT YOU ARE REQUIRED TO HIGHLIGHT THE BASIS OF INTERNATIONAL AND SHOW WHY YOU WOULD RECOMMEND INTERNATIONAL TRADE TO THE GOVERNMENT OF GHANA

3. Design and draw a circuit using the cascade system to operate two cylinders (A and B) which, on the operation of a start valve, produces the sequence A – B + B – A+. The cylinde

I have a project in power flow analysis. The project topic is: Study of Load impact on power flow (constant power, constant impedance, constant current, induction motor) and use th

How base case NPV analysis is applied in financial risk management

The self lubricating bearing is a typical application of metal powder parts or powder metallurgy process. The self lubricating bearings made from brass, iron, aluminium bronze etc,

Q.4 Explains subtractive rapid prototyping process and compare with additive process.                                                   OR What are additive and su

Special Casting Methods             1. Die casting : Die casting is a permanent mould casting techniques in which molten metal is forced in the mould cavity under a pressure