Push psw instruction , Electrical Engineering

PUSH PSW Instruction

It is similar to above  push  instruction but instead of normal  register Paris it use PSW as its  operand. Program status  word comprises of  the contents  of the  accumulator  and flag  register. The instruction format is

       PUSHPSW

Hence this  instruction  copies  the contents  of accumulator  and flag  register into the  stack.

The contents  of accumulator  flag  register remain unchanged .

Posted Date: 4/5/2013 2:44:21 AM | Location : United States







Related Discussions:- Push psw instruction , Assignment Help, Ask Question on Push psw instruction , Get Answer, Expert's Help, Push psw instruction Discussions

Write discussion on Push psw instruction
Your posts are moderated
Related Questions
Task 1 Use basic circuit theory to convert the "T" circuit below into the equivalent "π". Hint: Remember to disconnect the voltage source and the load. Task 2

Q. Show Transformer equivalent circuits? Transformers come in various sizes, from very small, weighing only a few ounces, to very large, weighing hundreds of tons. The ratings

Athree-phase, 440-V, 60-Hz, four-pole induction motor operates at a slip of 0.025 at full load, with its rotor circuit short-circuited. This motor is to be operated on a 50-Hz supp

Explain the working of BJT Amplifiers? The purpose of electronic amplifiers is essentially to increase the amplitude and power of a signal so that either useful work is done or

Global Positioning System: For power utilities, the basic objective of using Global Positioning System (GPS) and GIS should be to: enhance the efficiency of transmissio

The increase in the current is building up the magnetic field surrounding the coil. Energy is stored in that field. Consider the energy supplied by the voltage source during the

Explain Sampling at the Nyquist Rate? What would happen if we reduced the sampling frequency? In the time domain, we would be getting less samples for each period. In the frequ

Q. Signals and spectral analysis? Figure shows the functional block diagram of a signal-processing system. The information source may be a speech (voice), an image (picture), o

Q. Determine v, i, and the power delivered to elements in the network given in Figure. Check whether conservation of power is satisfied by the circuit.

Digital Transmission on Fading Multipath Channels We have discussed thus far digital modulation and demodulation methods for the transmission of information over two types of c