Polar modulus , Mechanical Engineering

Polar Modulus(Zp): 

It is the ratio of polar moment of the inertia to outer radius.

Zp = J/R

Polar Modulus of solid body (Zp) =[  ?/32.D4]/D/2 =  ? .D3/16

Polar modulus of hollow body (Zp) =[?   /32. (Do - Di  )]/D/2 = [  .(Do - Di  )/Do]/16

 

 

Posted Date: 10/23/2012 2:24:42 AM | Location : United States







Related Discussions:- Polar modulus , Assignment Help, Ask Question on Polar modulus , Get Answer, Expert's Help, Polar modulus Discussions

Write discussion on Polar modulus
Your posts are moderated
Related Questions
Explain the Evaluation Phase of auger shaft Evaluation Phase of auger shaft Steps: 1. To judge the ideas generated in the creation phase for ability to meet the required

Q. Piping Inspection and Test Plan? Piping Inspection and Test Plan review and Piping Materials Test Results review shall be by the Piping Materials group, or by / with assista

A rotor has the given properties : If the shaft is balanced by two counter masses located at 100 mm radii and revolving in planes midway of plan 1 and 2 and midway of 3 and

System of loads -  Beam: Build the SFD & BMD for 10 m span simply supported beam subjected to a system of loads as illustrated in Figure . Figure Taking moment a

Calculation for Stress-strain carves:   After reaching point D, if bar is strained further, a local reduction in cross section occurs in gauge length (that is, formati

Principle of equilibrium: Sol.: Principle of equilibrium can be divided in to three main parts; (1) Two Force Principle: As the Resultant is zero when body is in equili

Determine the resultant of the loads: A system of loads acting on beam is shown in the figure given below. Determine the resultant of the loads. Sol.: Let R be resultant


There are various methods to visualize the design process which can be summarized as given below: a. An automated drafting tool and presentation of graphics. b. A means

Calculate the Length of Developed Blank Part shown in Figure is to be produced from flat sheet by bending operation. Calculate the length of the developed blank. Assume k = 0.